The Utility of the Tie Wire for Assemble Welding of Each Component in the Gas Turbine

The result showed that it is in the period of droplet growth at the tip of welding wire that an electrochemically gained oxygen was produced in the case of direct current negative polarity whereas an electrochemically lost oxygen in positive polarity.

结果表明，在焊丝末端熔滴生长阶段，直流反极性条件下存在电化学增氧，而直流正极性条件下则存在电化学脱氧。

The kinetic and dynamic parameters of molten metal tip at the wire end during pulsed rotating spray transfer were surveyed by means of the technique of high speed cinematography and motion data processing system in this paper.

通过高速摄影技术和影片运动数据处理系统，测定了脉冲旋转喷射过渡时焊丝末端液锥的运动学与动力学参数，同时计算出焊丝末端液锥上承受的径向力和切向力。

The results showed that the tested top slag+ wire feeding slag had high sulphur capacity ( logC S being-1.6~ 0.5) which were available for desulphurization of ultra-low sulphur steel during refining;

结果表明，该顶渣+喂线渣具有高的硫容量（logCS为-1.6～0.5），适用于超低硫钢的精炼脱硫；

If a table is used, it should have a top made of wire screen or thin pieces of wood with space between each piece.

如果用桌子，那么桌面是由金属丝或者细木条网格制成的。

These entities are also part of the specification and form a layer on top of the wire level protocol: the AMQP model.

这些实体也是规范的一部分，形成了在线路层协议顶端的一个层级：AMQP模型。

To dry fish, you will need a place to them. If a table is used, it should have a top wire screen or thin pieces of wood with space between each piece.

为了把鱼晾干，你需要一个干燥桌或悬挂鱼的地方。如果用桌子，顶部必须是金属线网，或者是相互之间留有空隙的木片。

A progressive development mode of wire bar mill reformation

一种滚动发展的棒材轧机改造模式

Research on change law of depth of decarburization layer on surface of wire bar

对线材表面脱碳层深度变化规律的研究

A wire bar gives sufficient strength to avoid tower fatigue.

连接顶端和底端的钢丝绳可以避免机塔和底座过早疲劳。

If there is air gap, loose and poor insulation, the vibration and local over heat will occur during operation period, which can damage the insulation of stator's wire bar so that it will bring great threat to the safe operation of generator.

如果存在气隙、松动及绝缘不良等情况，在运行过程中会出现振动和局部过热，从而引起定子线棒的绝缘破坏，这对发电机安全运行将造成严重威胁。

For quantum structure lasers, including quantum well, quantum wire and quantum box lasers, a simple method is presented to obtain the optimized structure of the active region for low threshold condition.

针对低阈值半导体量子结构激光器（简称量子结构激光器），包括量子阱、量子线和量子点结构，给出了一个完整简便的方法用以优化设计最低阈值条件所需要的有源区结构。

The wire drawing mold box is connected with the drawing mold case by a beaming roller and a bearing.

拉丝模具盒通过轴辊、轴承与拉丝模具箱相连接。

Quantum Wire and Box Lasers: Next Generation High Performance Semiconductor Lasers

量子线和量子箱激光器&下一代高性能半导体激光器

Establishment of the Data Structure of 4 Axis Wire Cut Compiling Program

四轴线切割编译程序数据结构的建立

Introduced the characteristics of two kinds of wire cut clamps.

介绍了两种线切割夹具的特点。

Process points analysis for die and mould in wire cut machining

线切割加工模具的工艺要点分析

The optical CT technique was applied to pendulum wire coordinate measurement for dam deformation monitoring. A new type of pendulum wire coordinate gauge was developed which consisted of point light source array and CCD linear array.

把光学CT技术应用于大坝变形垂线坐标的测量，研制了用阵列光源和电荷耦合器件CCD线阵构成的一种新型垂线坐标仪。

The difference in the method between automatic monitoring and manual observation for dam deformation monitoring system was indicated. It discussed that the build method of automatic monitoring system for wire alignment in dam.

指出了大坝变形监测系统中自动化监测与人工观测方法的差异，对引张线自动监测系统的构建方法进行了论述；

Cordage of paper plaited or reinforced with metal Steel wire ropes& Spliced eye termination for slings

与金属编结或用金属加固的纸绳GB/T16271-1996钢丝绳吊索&插编索扣

Steel wire ropes& Spliced eye termination for slings

GB/T16271-1996钢丝绳吊索&插编索扣