Engineers used the trial and error method in selecting the other colors.

Summary : It discusses detail complexation retitrate point and error margin concrete reckon effect factors.

本文详细地讨论了络合返滴定终点误差的具体算式及其影响因素.

Verified by experiment, the error margin of the measure method is less than 5 %.

经实验验证, 该测量方法误差小于5%.

End application error margin compensate method, get ideal of fixed position accuracy.

最后应用误差补偿法, 得到理想的定位精度.

Error bounds for pseudoconvex multifunctions are considered.

考虑了伪凸集值映射的误差界.

RS ( 256,252 ) code is extended from RS ( 255,252 ) code , a byte-wide single error-correcting and double-error detecting cyclic block code.

RS ( 256,252 ) 码是由RS ( 255,252 ) 码拓展而来.

Design, error analysis and simulation of the antenna are presented.

给出了天线各部分的设计 、 公差分析和仿真.

In this thesis , different integrating schemes of joint source-channel coding error resilient image transmission over.

其中利用联合信源信道编码解决无线图像传输是目前该领域的研究热点之一.

It is trained once by actual error in each frame to reduce the estimate error.

CMAC每帧用实际误差训练一次,以减少其预测误差.

This one is an actual error.

这是很明显的错漏.

Write error report when find error.

发现错误后提交错误报告.

The rule made officially by Swiss says, that first-rate watch error is not beyond 10 seconds.

瑞士官方制定的规则说优等品机械手表每日误差应控制在10秒以内.

The influence of leveling staff error on the data of vertical crust deformation is discussed.

讨论水准标尺误差在垂直形变资料中的影响.

Setup error , please checks.

设置有误!

The ratio error of the divider calibration with this method is at 10-7 magnitude.

结果表明:用该方法校准的分压箱,比率误差为 10-7 量级.

The editor over seed a print error.

这位编辑漏掉了唯一印刷错误.

Zero Phase Error Tracking Controller ( ZPETC ) was used to partially solve the problem.

零相位误差跟踪控制器 ( ZPETC ) 的提出部分地解决了这一问题.

The declining memory filtering algorithm applied tothe effect of system model error the relative navigation.

仿真结果表明,该滤波算法可实现伴飞星的自主相对导航.

We thence analyze compendiously model error's influence of damage position and damage degree.

最后扼要地分析模型误差对损伤识别位置和损伤程度的结果影响.

With the increase of index the model error is weakened.

随着三角多项式阶数的增加,新模型中模型误差减小了.

Design software which used chart, UML chart and so on, this can make logic error little.

利用流程图, UML图 等工具来设计程序, 以避免逻辑上的错误.