When none of the sliding gears is in mesh with its countershaft gear, the gears are said to be in neutral.

He sat there with the car in neutral.

他坐在那儿，让汽车挂着空挡。

At the same time, the author discusses the problems and risks from drawing checks to accepting checks.

同时讨论了从支票交付到实际承兑这段空挡时间所产生的问题及其风险承担问题。

Leave a car in neutral gear.

让汽车排挡置于空挡位置.

Change up into fifth.

把车速调高到第五挡。

Research on Five-shift Transmission and Planetary Gear Transmission Scheme

五挡变速器行星齿轮传动方案研究

Out-of-mesh trouble in 4th gear was found in actual usage, but the trouble is solved by changing the synchronizer structure, increasing the rigidity of the synchronizer gear sleeve and etc.

在实际使用中，存在四挡脱挡故障，通过采取改变同步器的结构、增强同步器齿套的刚度等措施，该问题已得到解决。

Improved Design of Guide Plate for 4-Roll Calendar

四辊压延机挡胶板的改进设计

I was driving along in fourth gear.

我一直用第四挡开车。

Reliability Analysis of the 4.5-Gear Synchro-nizer of the 662-Type Train Gearbox

662型客车变速器四、五挡同步器的可靠性分析

When operating your vehicle in4L, the engine speed is approximately three times that of the2H or4H positions at a given road speed.

当你挂四挡进行驾驶时，发动机转速会接近你在2H或4H水平时的三倍（即使车是以同样的速度行驶）。

The car was in fourth gear

车挂的是四挡。

Good computer skill . Familar with AutoCAD R 14 or new version.

良好的计算机使用技能.

The open-structure of AutoCAD and its widespread users will set a good future for the system.

AutoCAD广泛的用户基础和完善的开放机制为软件系统提供了广阔的前景.

This paper introduces a method for creating shape and Chinese big font file automatically in AUTOCAD.

介绍AUTOCAD形和多字体汉字大字体文件的自动生成的方法.

Intermediate and above titles, use AUTOCAD and three-dimensional mapping software. 4, Job Location: Hefei.

中级以上技术职称, 会使用AUTOCAD及叁维绘图软件. 4 、 工作地点: 合肥.

Good computer skill and familiar with AUTOCAD.

良好的计算机能力,熟悉AUTOCAD绘图软件.

AUTOCAD secondary development the code, add the following few commands.

AUTOCAD二 次开发的代码, 加了下面几个命令.deteleText删除文字.

Intermediate and above titles, use AUTOCAD and three-dimensional mapping software.

中级以上技术职称, 会使用AUTOCAD及三维绘图软件.

Used mainly for editing AutoCAD drawings within the technical requirements.

主要用于编辑AutoCAD图形内的技术要求.

Do finite element analysis on the third shaft and gear shaft of shearer cutting unit. Then calculate the equivalent stress, such as cloud and the maximum stress value.

针对采煤机的薄弱环节截割部的截三轴和太阳轮进行有限元分析，得出其等效应力云图及最大等效应力值。