Because push-rod valve train has additional parts, it is more difficult to run at high speeds.

Operating Principle: The pressure seal valve is a hand wheel-operated valve using a two-piece valve stem.

运转原理: 压力密封阀是使用两个阀杆的手轮操作阀门.

The molded step of the diaphragm should point down towards the relief valve stem.

隔膜的模制台阶应该对着安全阀阀杆.

These sets consist of a coupling which attaches to standard valve stem and an extension rod.

这些装置由可连接标准阀门阀杆的联结器和加长杆组成.

Mounted vertically, the valve cover, valve stem should be outward.

垂直安装时, 阀盖 、 阀杆应朝外.

Hammer blow and standard valve stem coupling designs available.

锤击和标准阀杆耦合设计可用.

The valve, the valve seat valve and plunger usually is based on the principles of design.

在该阀门中, 阀瓣和阀座通常是基于柱塞原理设计的.

Now generally used PTEE, EPDM and other material for the valve seat, so bubbles leakproofness good.

现一般均使用PTEE 、 EPDM等材料,为阀座, 因此,气泡密封性佳.

The valve seat diameter.

阀门阀座直径.

The closing valve stem and valve seat sealing surface axis vertical.

截止阀的阀杆轴线与阀座密封面垂直.

Place the relief valve seat back into the chamber bore.

将安全阀阀座放回到镗孔内.

Slide the diaphragm assembly into the relief valve seat.

将隔膜总成滑进到安全阀阀座内.

Magnetic valve seat, diaphragm and valve plate combined design.

磁性阀座 、 覆膜阀片组合设计.

Globe valves are usually installed with the inlet below the valve seat.

安装截止阀时,通常把进口安装在阀座下方.

A butterfly valve seal and metal shells of the two sealed sealed type.

蝶阀有弹密封和金属的密封两种密封型式.

Valve timing and valve lift are key technical parameters of an engine.

配气相位、气门升程是发动机最关键的技术参数指标之一.

Manual is a manual lever manipulation direction change valve disc killer direction control valves.

手动换向阀是用手动杠杆操纵阀芯移位的方向控制阀.

Replaceable Stainless Steel Seat and Valve Disc.

可更换不锈钢阀座和阀瓣.

Replaceable Steel Seat and Valve Disc.

可更换不锈钢阀座和阀门阀瓣.

Too much valve clearance causes a lag in valve timing causing engine valve train imbalance.

气门间隙过大会引起气门调时延迟,造成引擎气门组系不平衡.

Furthermore, this thesis also states the checking and adjusting method of valve timing and valve clearance.

并介绍了配气相位和气门间隙的检查调整方法.