The certification to this Technical Specification includes customer-specific requirements if any.

Annex A forms a normative part of this Technical Specification.

附录A是标准的附录,构成本标准的一部分.

The equipment design must grow by continual interplay between the technical specification and the packaging.

仪器设计必须根据工艺指标和装配之间不断地交互影响而发展.

After the wall energy unit area of high load capacity, high surface temperature, the lampdimming life.

确定后,则管壁单位面积能量负荷大, 管壁温度高, 灯管寿命低.

The contour dimension of the booster is greatly decreased and the output load capacity is improved.

可以有效地减小增力装置的外形尺寸,并提高输出负载力.

So blade plays a decisive role in respect of flying speed, effective load capacity and flexibility.

因而,它对飞机的飞行速度、机动性 、 有效载重起着决定性作用.

There may also be several criteria, as load capacity, durability, life, and ease of repair.

也可能有一些标准, 如荷重 、 耐久性 、 人生观 、 维修方便.

It has density, good load capacity and wear-resistant.

它具有高密度, 有良好的承载压力及很好的耐磨性.

Good load capacity and anti-wear.

承载好,耐磨性能良好.

Strong load capacity of shaft , service life long.

轴载荷能力强, 工作寿命长.

The trucks has a full load capacity of six tons.

这辆卡车的车容是六吨.

In this paper, notch sensitivity of a low-carbon bainitic steel under static load has been studied.

本文研究了回火温度对 低碳 贝氏体钢静载缺口敏感性的影响.

The car and its survival cell must pass several strict impact, roll and static load tests.

赛车及其支架必须通过几个严格的撞击, 轧辊与载重测试.

Objective : To discuss the relation of lipid peroxidation to muscle injury caused by static load.

目的: 探讨静态负荷致骨骼肌损伤与脂质过氧化的关系.

First of all, the basic principle of static load sharing mechanism has been studied.

首先, 从静力学的角度研究了行星齿轮传动系统均载的基本原理.

Implicit linking is sometimes referred to as static load or load-time dynamic linking.

隐式链接有时称为静态加载或加载时动态链接.

High mechanical strength, it can stand heavy dynamic and static load.

机械强度大, 能承受较大的动、静载荷.

Can Static Load Test Reflect True Conditions of Composite Foundation?

静载试验能反映复合地基承载力的真实情况 吗 ?

The oil film of sliding bearing was squeezed and sheared in the dynamic load conditions.

滑动轴承在动载工作条件下运行时,承载油膜受到轴承挤压和旋转剪切两种运动作用.

Because of low fatigue limitation of shaft enduring dynamic-load stress rupture is happened.

对此,在提高轴头疲劳极限和降低变应力两方面采取了相应的改造措施.

A conclusion isthat the lifting dynamic load can not be neglected while lifting acceleration is big.

结论认为,当起升加速度较大时,其起升动载不可忽视.