The composition, functions and technology targets of microcomputer monitor system for 6502 electric equipments are given.

This paper represents a gas density monitor system.

介绍了一种微机控制气体浓度监测报警系统.

This paper presents a gas density monitor system.

介绍了1种微机控制气体浓度监测报警系统.

Setup and Calibration about Yield Monitor System of Case 2366 Combine.

CASE2366联合收割机产量监测系统设置及校正.

How do I enumerate the display devices in a multi-monitor system?

我如何在 多显示器 系统中列出各个显示设备?

Finally, the author proves his approach by analyzing an example of sand mould casting.

最后通过砂型铸造实例分析,验证了该方案.

Experienced with sand-mould , expert at casting process.

具有砂型铸造工作经验,对铸造工艺过程有深入了解.

Minimum 3 years experience of accurate injection molding mould design and injection molding technics tracking.

有3年的精密注塑模具设计和注塑工艺跟踪经验.

The mould design and manufacturing process of the bus lock hole was introduced.

介绍客车前围冲锁孔的模具设计及制造工艺.

Participate in the confirmation of mould design.

参与模具结构设计的确认.

Mould design and manufacture for above products.

以上各类产模具设计,开发,制造.

The stamping process and mould design of frame are introduced.

介绍了行李架的冲压方案确定及模具设计.

Excellent mechanical understanding related to injection and stamping mould design.

注塑,冲压模具设计方面优秀的领悟能力.

The workpiece was done successfully by mould design, manufacture and test.

通过模具设计 、 制造和调试,成功地实现了计时器盒盖的成型.

The construction, function and basic principle of computer simulation system for injection mould were introduced.

简要介绍了注射成型过程计算机模拟系统的组成 、 功能及主要技术原理.

A method of automatic generation of feature-based injection mould core & cavity is put forward.

提出基于特征的注射模具型 芯 型腔自动创建的实现方法.

The structural design and operating process of an injection mould for the part were introduced.

分析了电熨斗大身的工艺特点,介绍了电熨斗大身注射模结构设计和工作过程.

The general design principle of gas assisted injection mould design is discussed.

阐述了气体辅助注射模具设计的一般原则,介绍了气针的工作原理和选择方法.

Key words: hose-connect 、 injection mould 、 take off whorl 、 side core.

关键词: 软管接头、注射模、脱螺纹、侧向抽芯.

This thesis deals with the design of injection mould of plastic.

论述塑料制品的注塑模设计.

Plastic injection mould-coolant passages, eject pin and electrical heating holes.

塑胶射出模具 - 冷却水孔 、 射梢孔及电热孔.