The superstructure a depth of 3 ft . 6 in. a marked camber of 19 ft . 8 in.

Long lengths of unsupported strip camber tend to deviate from the horizontal or slope to side.

长距离无支持的钢带偏离水平线或偏向一侧.也可参见以下部分.

" To Camber Company, please . It's on 32 nd avenue . "

去 坎培克斯 公司. 在第32街上.

Inward tilt is negative camber and outward tilt is positive camber.

向内倾斜,是消极的拱和拱向外倾斜是积极的.

In this thesis the basic aspects about forming process of camber die are studied etically.

本论文对曲面凹模成形工艺的若干问题进行了系统的理论分析.

The camber is curvature of the cross section and the crown is the highest point camber.

图中向上倾斜部分是路拱,该部分的最高点是路脊.

The measures for improving wear of camber for lockup were proposed.

针对锁紧弧面的磨损提出了改善措施.

Camber line won " ts do orthogonal arc tooth wimble gear. "

中心线 不成 直角的弧齿锥齿轮.

Application of low Mooney viscosity, non pollution type NBR to thin camber sponge rubber was studied.

研究低门尼粘度 、 非污染型丁腈橡胶在薄型曲面海绵胶料中的应用.

This provides an increased damping rate and allows a slight reduction in camber angle.

这样就增加了减震度,并且可以稍微减少外倾角.

The front subframe is modified for extra camber and castor.

前副车架被修改为额外拱形和蓖麻.

A taper has two sides, the underside is a circle, the flank is a camber.

结论:圆锥有两个面, 底面是一个圆形, 侧面是一个曲面.

The larger permeability damage modulus and the earlier the IPR curving and the camber was.

渗透率伤害系数越大,曲线弯曲越早,弯曲度越大.

The tilt of the wheel ( camber ) is measured in degrees and is adjustable on many vehicles.

该轮 ( 弯度倾斜 ) 是衡量度,是许多车辆可调.

The automatic camber control system of the line is introduced completely in the paper.

本文将对该生产线的自动凸度控制系统作全面详细的介绍.

To verify Restaurant Cashier's receipts against machine tape readings.

核对餐厅收银发票和收银机上显示的金额是否一致.

Temperature readings are stable, and the bucky cables are still radiating heat perfectly.

温度显示是稳定的, 电缆管仍源源不断的把热量散发出去.

How do I know that any of these readings I've been taking are correct?

我又如何知道,我所感知的哪些是真实的?

In interpreting Miss Bart's state of mind, so many alternative readings were possible.

在分析巴特小姐的心情时, 竟然得出那么多性质完全不同的结论.

It is best to record and plot all compass readings as true bearings.

记录和标绘的罗盘读数最好都是真正的方位.

To eliminate possible internal maladjustments, " A pattern readings " are made in sets of four.

为了消除可能存在的内部失调, “ A标尺 读数 ” 要以四个读数为一组.