This system traps the gasoline vapor excaping from the fuel tank and carburetor.

Fuel delivery system can be divided into two categories, carburetor and fuel injection.

燃料供给系统可分为化油器和燃料喷射二大类.

In the roundpiston VV carburetor, the piston is moved by intake-manifold vacuum.

在圆形活塞的VV化油器中, 活塞是由进气歧管真空移动的.

Dirt fouled the carburetor.

污垢弄脏了汽化器.

Carburetor and carburetor parts.

化油器化油器零件.

How about your carburettor?

您的汽化器怎么样?

Carburization characteristics and wear behavior of new type meta bainitic steel were studied.

研究了新型准贝氏体钢渗碳特性及渗层磨损性能.

This technical process is simple, carburization is stable, application is widely.

利用石墨煤增碳的炼钢技术,工艺简单可行, 增碳稳定, 应用广泛.

Distortion of automobile synchronizer gear sleeves will take place during the course of carburization and quenching.

汽车同步器齿套在渗碳淬火后,发生变形.

The result shows that carburization was the major factors inducing the failure of the furnace tubes.

结果表明,渗碳是引起炉管失效的主要因素.

Carburization of molten iron in the dropping zone of BF has been studied.

高炉铁水渗碳的主要阶段在滴落带,炉缸内的渗碳过程不会掩盖滴落带的渗碳规律.

Abstract: The carburizing process of steel 20 with and without RE addition was investigated.

文摘: 研究了不含稀土与含不同量稀土的20钢经过气体渗碳后的渗层厚度及试件从表层向内部的硬度变化.

A new research & development of continuous gas carburizing furnace is described.

介绍了新 研制 的网带连续式气体渗碳炉.

The regularity and the control of the distortion in carburizing process are also preliminarily investigated.

初步探讨了渗碳变形规律及控制方法.

The carburizing process of steel 20 with and without RE addition was investigated.

研究了不含稀土与含不同量稀土的20钢经过气体渗碳后的渗层厚度及试件从表层向内部的硬度变化.

The paper researches the effect of rare earths on carburized layer during carburizing operation.

研究了稀土元素庄渗碳过程中对渗层组织的影响.

The result will take active action on improving discharge techniques in gas carburizing.

这一结论对改进渗碳排气工艺将产生积极的作用.

As a raw gas for carburizing, it is necessary to desulphurize in the gas sufficiently.

所以作为渗碳用原料气必须对天然气充分脱硫.

A newly developed BBH pre-vacuum pumping carburizing furnace has been introduced in this paper.

介绍了新研制的预抽真空式可控气氛气体渗碳炉.

The feasibility and relative process for altering temperature and low pressure carburizing were studied.

研究了变温低压(真空)渗碳技术的可行性和相关工艺.

Nonsymmetrical carburizing may also contribute to distortion.

渗碳的不对称也可能导致变形.