Impeller are open, and closed three-Banbi, as shown in Figure 2-2 .

Single suction, single stage horizontal centrifugal pump with closed impeller.

单吸 、 单级卧式离心泵,用封闭叶轮.

YJD star unloader valve and welded steel impeller can also be cast.

YJD星型卸料器阀体和叶轮可用钢板焊制,也可铸造.

The flow of air through the fan is substantially parallel to the impeller axis.

通过风机的气流基本上是与叶轮轴平行的.

In addition, the correlations of for some better impeller-baffle-sparger combinations were obtained.

此外, 给出了几种较好桨型 - 挡板 - 分布环组合的临界搅拌转速关联式.

Too much wear with dual-suction seal ring or impeller damaged.

双吸密封环磨损过多,或叶轮损坏.

The condition for obtaining the minimal number of impeller revolutions is determined.

确定了获取最小叶片转数的条件.

The impeller of the sea water pump is unevenly worn out.

海水泵叶轮严重单边磨损.

Strainer or impeller blocked Triangle speed is too low or too loose.

滤网或叶轮堵塞,转速太低或三角带过松.

Impeller has single-and double-suction suction aspiration of the two methods.

叶轮有单吸和双吸两种吸液方式.

Whirlpool Qibeng the impeller similar large gas turbines impeller.

漩涡气泵的叶轮类似庞大的气轮机的叶轮.

The impellers are elaborately designed and made, optimized for low noise level and lower energy consumption.

叶轮经过精心设计和加工, 噪声低、效率高.

A novel surface aeration reactor is designed with incorporation of-rotating flow guide multiple impellers.

应用多层桨自旋导流技术,设计了一种新型自旋导流表面曝气反应器.

DYNAMICALLY BALANCED IMPELLERS-Perfectly balanced for vib-ration-free high-speed service.

叶轮的动态地平衡 — 完全平衡为无振动 高速 服务提供完美性能.

It features adopting new type pneumatic sealing device, special-shaped impellers and pre-segregation system.

其特点是引入了新型气动密封装置 、 异形叶片与预分散系统.

Welding is one of the important technologies in impellers " artifactitious . "

焊接是 叶轮 加工的重要工艺之一.

Mixing plane model was used in mutual faces between impellers.

在叶轮之间的交互面上使用混合平面模型.

Mainly by the impellers, pump body and pump cover composition.

主要由叶轮 、 泵体和泵盖组成.

This paper presented the flow field analysis in centrifugal impellers compressing perfect and real gas respectively.

目的是讨论离心式叶轮内理想气体与实际气体流场分析结果之间的差异.

Collision avoidance is a critical problem in the 5-axis machining of three-dimensional impellers.

在三元叶轮的五坐标加工中,碰撞干涉的有效避免是最为关键的问题.

The impellers are kept in their proper relationship to each other by spur gear.

液轮之间借助于正齿轮保持彼此正常的关系.