It is always good to set additional players case of substitutions.

I have made the substitutions required in this book.

我在本书中已应需要作了改换.

Substitutions must occur at or within the team's substitution box.

替换必须发生在本队内的替换区.

A team is allowed a maximum of 6 substitutions per game.

每局允许最多6次换人.

Jos é's three substitutions, ending in a 3-4-1-2 formation, told their own story.

何塞的三个换人后,把阵形换成 3-4-1-2, 开始上演他们的进攻大战.

They allow no substitutions on the club luncheon.

规定午餐的套饭不得换菜.

The scale bar shows the number of substitutions per base.

标尺长度表明每个碱基发生0.05次置换.

Two substitutions ( ie of players ) were made during the match.

在比赛中换了两次人.

His substitutions are so bold yet almost always effective.

他所安排的替换是如此的大胆然而却差不多总是有效的.

Non-metal atom substitutions also generated numerous bogus organic structures.

非金属 原子换人也孕育发生了许多虚伪的有机布局.

From the point of energy stratagem, the biological diesel oil is the most important substitutive fuel.

从能源战略角度分析, 生物柴油是最为重要的代用燃料之一,柴油机不需改动即可使用生物柴油.

So far no substitutive material has been found to match its properties.

其优越性在同类产品中有不可替代的作用.

Studying the substitutive measure of detention must begin with its theoretical foundation.

确立羁押替代性措施,必须以其理论基础为依据.

Push device is firm, good distance for changing substrate material.

该推动装置设计坚固, 推动距离大,方便基材料的穿越.

These parameters include: substrate, roller, printing ink and its delivery.

这些参数主要包括: 承印物 、 网纹辊 、 油墨及其传递.

Cyclamen persicum was carried on with substract culture testing by useing of different complex substrate.

摘要用不同复合基质对仙客来进行基质栽培试验.

The dispensing height has direct influence the process of fluid transferring from needle tip to substrate.

胶液分配高度直接影响接触式胶液分配系统胶液从针头向基板的转移过程.

The story has a substratum of truth.

这故事有事实的基础.

Design rig's mast structure & rig's substructure.

油井的钻机的井架,珩架及底座结构件的应力分析 和 设计.

And, guided by the analysis result, a triangle plate substructure was added to the fixture.

并根据分析的结果, 在夹具中增加了角板子结构.

The microstructure and substructure of white cast iron during recovery and recrystallization were studied with TEM.

本文介绍利用透射电镜观察塑性加工后,白口铸铁形变、呈复和再结晶过程的组织及亚结构的变化.