Properties of intumescent flame retardant ethylene propylene diene monomer/ polypropylene thermoplastic vulcanizate

The effects of radiation environment, radiation dose, monomer concentration and reaction temperature in terms of grafting parameters were investigated systematically.

系统研究了辐射气氛、辐射总剂量、单体浓度以及聚合反应温度对体系接枝参数的影响。

The results show that the reaction rate is in direct proportion to one power of monomer concentration and a half power of initiator concentration;

实验结果表明，在聚合反应初期，聚合反应速率与引发剂的浓度呈半级反应，与单体浓度呈一级反应；

The effects of polymerization conditions, such as initiator concentration, monomer concentration, reaction time and temperature, on grafting parameters were studied.

研究了各种聚合条件如：引发剂浓度、单体浓度、反应时间、温度等对接枝参数的影响。

The relationship between ratio of graft and cerousion concentration, monomer concentration, temperature of reaction were discussed.

讨论了接枝率与铈离子浓度、单体浓度、温度的关系；

The influencing factors such as granularity of raw materials, dosage of initiator and monomer concentration was discussed.

讨论了原料粒度、发剂用量以及单体浓度等因素对反应的影响。

High irradiation dose, monomer concentration, inflated with nitrogen increased chloramphenicol degrading efficieney;

辐照剂量高，单体浓度低和充氮，降率高；

With increasing reaction time, monomer concentration and photoinitiator content, the diameter of particles with polymer brushes increased.

含高分子刷的微球尺寸随着反应时间、单体浓度以及光引发剂用量的增加而增大。

The effects of initiator concentration, monomer concentration, starch concentration and temperature on the percentage of graft were investigated.

考察了引发剂浓度、单体浓度、淀粉浓度和反应温度时接枝率的影响。

Grafting temperature and monomer concentration were investigated.

探讨了预辐照剂量，辐照气氛，接枝反应温度以及单体浓度对接枝共聚反应的影响。

Studies on Preparation of Superabsorbent at a High Monomer Concentration

高单体浓度下自交联型聚丙烯酸盐类超强吸水剂的合成研究

It was found that conversion and molecular weight were decreased with the increase of monomer concentration.

研究发现：随单体浓度的升高，转化率和分子量同时下降。

The graft polymerization processes could be controlled by monomer concentration, UV-irradiation time and photoinitiator concentration.

接枝聚合过程可以通过改变单体浓度、紫外辐照时间以及光引发剂浓度来进行调控。

The relationships of molecular weight and monomer concentration, initiator concentration show that the polymerization reaction system has the characteristic of living polymerization.

分子量与单体浓度、引发剂浓度的关系说明，该体系具有一定程度的活性聚合特点。

Kinetic studies show that polymerization proceeds with first-order dependence on both monomer concentration and initiator concentration.

聚合反应的动力学实验表明单体和催化剂浓度对该聚合反应的反应速率都表现为一级。

The grafting percentage increases with the increasing of reaction time and monomer concentration.

反应时间长，单体浓度高，接枝率越高。

Effeets of monomer concentration and reaction time on the graft copolymerization were studied.

考察了单体浓度、发剂浓度、合温度对接枝共聚反应的影响。

The effects of monomer concentration, reaction temperature, initiator dosage on polymerization rate and intrinsic viscosity of product were investigated.

探讨了单体浓度、反应温度、引发剂用量等因素对聚合反应速率和产物特性黏数的影响。

Monomer concentration, 40% ( water system), respectively.

单体浓度为40%（水相）。

The inverse microemulsion polymerizations at the high monomer concentration

高单体浓度下反相微乳液聚合

The other preparation conditions, such as monomer concentration, temperature, and time of polymerization, were systematically studied.

本文还对其它制备条件，比如单体浓度，温度，聚合反应时间都进行了系统研究。