Compressed wood up to medium-hard wood, aluminum, synthetic and plastic boards.

Gas source selection, according to Air Track needs to hate the characteristics of the compressed gas.

气源的选择, 要恨据气垫导轨需要压缩气体的特点而定.

Descaling technology sorted compressed gas descaling , pressure water descaling, sand blast descaling by different descaling medium.

根据除鳞介质的不同可将除鳞工艺分为高压水除鳞、压缩气体除鳞 、 喷沙除鳞.

Liquid cylinders designed to dispense gases have valves equipped with standard Compressed Gas Association ( CGA ) outlets.

设计用来输出气态氧的液体钢瓶上装有配有标准的压缩气体协会排气口的阀门.

Provide power supply, compressed gas or water.

提供动力电 、 压缩气或水源.

The compressed gas exerts an increased pressure.

压缩气体产生了更高的压力.

Store only the amount of compressed gas required for the specific application.

只储存专门应用所要求的压缩气体数量.

There are three basic valves used in the compressed gas industry.

在压缩气体工业中有三种基本的阀门.

The circle section is rather reasonable for axial compressed member.

在轴向受压构件中,用圆形截面也是合理的.

Shift free space between this drive and its compressed drive.

在驱动器和其压缩驱动器之间移动可用空间.

Shifts free space between a compressed drive and its host.

在压缩驱动器及其主驱动器之间交换可用空间.

My hands hurt . Could you put ice-cakes into the bags and give my hands cold compress?

我的手受伤了,你可否将冰块装在袋子里,让我敷一下.

If the silt has been blue inflamed, should hurry the hot compress or the ice compress.

如果淤青红肿了, 应赶紧热敷或冰敷.

Objective To investigate the clinical effectiveness of hot compress on the polarized liquid intravenous infusion-induced pain.

目的观察热敷法对静脉滴注极化液所致疼痛的疗效.

A hot compress can also help to relieve the discomfort.

热敷也可减轻局部不适.

The strut can be treated as compression member constrained by lateral translation nonlinear spring.

撑杆可以看成是含有平移弹性约束的轴心压杆结构.

Cylinder Compression Pressure Test.

汽缸压缩压力测试.

The flow stress obtained in micro compression test was modified to eliminate the influence of friction.

结合微压缩实验讨论了流动应力的修正,即消除摩擦力对微压缩的影响.

In addition, three familiar sets of softened compression stress-strain relationship of concrete are showed.

此外, 也给出了常见的三种软化压应力 - 应变关系方程.

If the stress is above yield point, the column will be destroyed due to compression stress.

时成立.应力在屈服点以上时,由于压缩应力, 柱子将会破坏.

Three compression stress state is the main stress state for three-roll planetary rolling process, which m.

得出在三辊行星轧制过程中起到主要作用的是三向压应力状态, 有利于坯料的大变形和提高轧制管材性能.