An investigation of compression-relaxation and compressive creep of carpets

A preliminary study on compressive creep of scalp

头皮压缩蠕变性的初步研究

Early-age stress analysis of concrete diaphragm wall through tensile and compressive creep modeling

考虑拉伸与压缩不同徐变特征的混凝土连续墙早龄内应力分析

Measurement Method of Compressive Creep Property of Rubber

橡胶压缩蠕变性能测试方法

The linear damage rule was applied to predict the life of cc type cycle that contains both tensile creep and compressive creep.

对同时包含拉/压蠕变的循环，采用线性累积损伤法则预测其寿命。

Research on Compressive Creep Behavior of the High Aluminum Zinc Based Alloy

高铝锌合金压蠕变行为研究

The properties of the amalgams of spherical powders, such as dimension change during hardening, compressive strength, flow and creep meet the specification No.

球粉汞齐的性能，诸如固化过程中的尺寸变化，压缩强度，流变及蠕变等均达到美国牙医协会技术指标。

Rotation of whiskers and its effect on high temperature compressive flow stress of sic_w/ al-ni composite

晶须转动及其对SiC W／Al－Ni复合材料高温压缩变形流变应力的影响

The volume strain forms a compressive region at the centre area of reservoir, and a tensile at the bank area and expands in all directions being consistent with the distribution of epicenter of induced earthquake.

体应变一般在库中心位置形成压缩区，而在库岸边则形成拉伸应变区并同时向四周扩展，与诱发地震震中分布相一致。

The method to define the ultimate limit state of carrying capacity, critical failure, critical strengthened quantity and critical height coefficient of concrete compressive region is suggested.

对粘贴碳纤维布抗弯加固梁正截面承载能力极限状态、界限破坏状态以及界限加固量进行了合理的界定。

Under dynamic loading, buried pipe would first damaged in compressive region of bilateral fault, so special treatment should be done to pipe in bilateral fault region.

在受动荷载作用时，管道在断层两侧受压区先破坏，故在断层两侧要进行特殊处理进行防护。

The analytical results show that, as the transverse rigidity decreases, the area of compressive region increases and the longitudinal effective rigidity ratio decreases.

结果表明，随横向刚度减小，截面受压区面积增大，隧道纵向等效刚度有效率减小；

The meanings of relative-boundary compressive region's height ξ_b

相对界限受压区高度ξb的意义

Because of the existence of prestress, the compressive region is enlarged and the primary bending stiffness is developed.

在正常使用状态下，由于预制断面上荷载预应力的存在，增大了断面的有效受压区面积，从而提高了叠合构件的初期抗弯刚度。

Simplified Formulas of Height of Compressive Region of Partially Prestressed B Type Member

部分预应力B类构件受压区高度简化计算

The Compression Creep Behavior of a Polycrystalline Graphite at High Temperature

一种多晶石墨材料的高温压缩蠕变行为

Compression Creep Behavior at High Temperature of 2618 Aluminum

2618铝合金高温压缩蠕变行为研究

Experimental Study on Compression Creep Characteristics for Nanning Unsaturated Expansive Soils

南宁非饱和膨胀土压缩蠕变特性试验研究

Inversion of compression creep parameters of deep rock under rigid bearing plate

刚性承压板下深部岩体压缩蠕变参数反演

FEM Analysis on the compression test methods of composite materials

复合材料压缩试验方法有限元分析

Study of initial damage and damage development of concrete by compression test

混凝土压缩时初始损伤及损伤演变的试验研究