At steam curing and moist curing conditions, the mechanical properties of concrete with different fineness and different proportions of ultrafine fly ash slag composite were studied.

The numerical simulation method can be used to optimize the curing temperature cycle, which can improve the quality of composite products.

模拟程序可以计算得到任意时刻复合材料内温度及固化度分布，通过数值模拟可以有效地优化固化加热工艺参数，提高产品质量。

The improvement of peroxide crosslinked EPDM properties with trimethylolpropane triacrylate ( TMPTA) was studied. It was found that the crosslinking rate and crosslinking density increased and the curing cycle time reduced with the addition of TMPTA in the peroxide crosslinking system for EPDM/ silica compound;

在EPDM／白炭黑胶料的过氧化物硫化体系中，加入三羟甲基丙烷三丙烯酸酯（TMPTA）能够迅速提高硫化胶的交联效率，增大网络密度，缩短硫化时间；

The test results showed that at a tailings/ cement ratio of 6 ∶ 1 and paste backfill density of 80% and 28 day curing cycle, the compressive strength reached 3.79 MPa;

试验结果表明，在尾砂水泥比为6∶1，浓度80%时，28d抗压强度达到3.79MPa；

The curing cycle shortened significantly as the level of Calcene CC in SBR or BR compounds increased.

在SBR和BR胶料中随白燕华CC用量的增大，硫化时间明显缩短。

The curing cycle of polymeric composites has significant effect on its performance and economic indices.

聚合物基复合材料的固化制度是影响其性能经济指标的重要因素。

Study on the Appearance and Chemical Variation Relationship of Burley Tobacco Leaves in Air curing Process

白肋烟晾制过程中烟叶外观变化与内在变化关系的研究

Studies on change of main chemical components of burley tobacco during air curing process

不同晾制阶段白肋烟主要化学成分的变化

Sealant such series of the water used for air curing.

此类密封胶系列用空气中的水分进行硫化。

Contrast Study on Properties of Three Type Air Curing Fluorocarbon Coatings

三种常温固化氟碳涂料性能的对比研究

The property of type 750 bulk Curing Barn baking chamber and the matching baking technology was the Gradual baking technology.

即750型卧室密集型烤房相匹配的烘烤工艺为：渐进式烘烤工艺。

The two problems such as the escape of SiF 4 gas and the break of cutting axle, occurred in curing chamber in calcium superphosphate production, were analyzed. The reform measures were put forward and put into effect, so that those two problems were solved.

分析了过磷酸钙生产中化成室出现的氟气外溢与切削器断轴两大问题，提出了改进措施，实施后上述问题得以解决。

Oxygen is purged from the chamber using nitrogen gas, which is introduced in a controlled manner via a'nitrogen knife'at the web inlet and via an injector in the curing chamber.

清除氧是由室内使用氮气，这是实行控制的方式通过'氮刀'在网络入口，并通过一个注射器在治疗室。

Design of Curing Chamber Heat System for Colored Cement Tile and Their Curing Technology

彩色水泥瓦养护窑供热系统的设计及其养护工艺

Controlling the oxygen level within the curing chamber is simply a matter of adjusting the nitrogen flow rate until the desired reading is obtained.

控制范围内氧气水平的固化室是一件简单的事，调整氮气流量，直至理想的阅读获得。

The system features a sealed curing chamber built around a small idler roller.

该系统采用了密封固化室围绕着一个小惰辊。

In order to reflect really the frost resistant properties of specimen, it is suggested that in the practice of project, the specimen shall be cured by the methods of" standard curing", spraying water curing, or using straw mattress to cover it.

为真实反映试件混凝土抗冻性能，建议在工程应用过程中，试件采用标养或洒水、草袋覆盖养护方法。

The influence of four types of curing methods such as standard curing natural curing, water curing and curing method designed independently upon the strength and shrinkage of pulverized fly ash high performance concrete ( HPC) is studied.

试验研究了标准养护、自然养护、浸水养护以及一种带模供水养护方法对粉煤灰高性能混凝土的强度和收缩的影响。

Chitin is a kind of natural macromolecular material whose reserve is only next to cellulose, its derivatives preparation and application in water curing are introduced.

甲壳素是继纤维素之后为地球上最丰富的高分子材料。本文介绍了甲壳素衍生物的制备及其在水处理中的应用。

Heat-curing benefits the increase of strength which can still develop in 28 day water curing after heat-curing.

热养护有利于强度的提高，经热水养护后放置水中至28天龄期，其强度有较大提升，并没有出现强度倒缩现象。

The early water curing of concrete is longer and then the rate of late drying shrinkage of concrete is faster.

延长混凝土的早期水养时间，并不会减少混凝土的干燥收缩值，反而会使干缩速率加快；