Finally, the application of breakeven analysis as a flexible budget device is introduced.

An Application of Breakeven Analysis to the Eastern Oil Refining Factory

盈亏分析在东方炼油厂的应用

Computer algorithm of breakeven analysis for multiple variety production

多品种生产盈亏分析的计算机算法

Breakeven Analysis on Investment Item Under the Undeterminate Conditions

不确定条件下投资项目的盈亏平衡分析法&传统盈亏平衡分析的扩展

During working process, such mechanical failure as teeth breakdown of transmission system and plastic deformation of load flat appears frequently, which result in the break of production, even the paralysis of whole product line, so tremendous economic loss is inevitable for corporations.

工作过程中常常出现传动系统齿断、载荷平台塑性形变等机械故障，由此导致生产断续，甚至造成整条生产线瘫痪，给企业带来巨大经济损失。

On-line condition monitoring and signal analysis is a new developing technology that has been developed to meet the need of modern manufacture in recent decades, and it has been justified in practice as an effective technology for protecting mechanical equipment from breakdown.

在线状态监测与信号分析是近年来为适应现代化生产而发展起来的一门学科，已经被实践证明是提高机械设备运行可靠性的一个行之有效的手段。

The Study of the Cause and Solution of Mechanical Sealing Breakdown of MHB5/ 5 Boiler Feed Pump

MHB5/5锅炉给水泵机械密封故障分析及解决方法探讨

Present Situation and Development Tendency of Examination and Diagnosis Technology about Mechanical Equipment Breakdown

机械设备故障检测诊断技术的现状与发展

When a major mechanical breakdown occurs it can cost the homeowner thousands of dollars.

当发生重大机械故障可以成本房主几千美元。

Cause analysis of mechanical breakdown associated with a small turboexpander and solutions

小型透平膨胀机机械故障原因分析及处理

At low room temperature we studied such influencing factors on the breakaway torque as injection quantity of magnetic fluid, number of sealing stages, and the standing time at normal temperature.

以-40℃，直径为140mm的磁性液体密封为例，在低温室内研究了影响磁性液体密封起动扭矩大小的因素，如磁性液体注入量，密封的级数、常温（15℃）下放置的时间等。

A key factor restricting the application of magnetic fluid rotation sealing at low temperature and large diameter is the high breakaway torque.

制约低温大直径磁性液体密封在实际应用中的关键因素之一是起动扭矩过大。

Study on the breakaway torque of magnetic fluid sealing at low temperature and large diameter

低温大直径磁性液体密封起动扭矩的研究

Breakaway Torque is the total of the three factors listed above.

最小开机扭矩是上述三项因素的总和。

Specification for vessel, pipework and breakaway coupling;

盛器、喉管及断开式联轴节规格；

The Mechanism of Drawing Breakage

引伸破裂的机理

Analysis and improvement of CT secondary breakage criterion in generator differential protection The Mechanism of Drawing Breakage

发电机纵差保护CT二次断线判别原理的分析和改进引伸破裂的机理

The numerical simulation of sheet forming can predict and display crinkling, drawing breakage and variation of sheet thickness in the process of drawing. The physical process, mechanical model and typical simulation process for sheet forming are described.

板料成形的数值模拟可以预测并显示板料在拉深过程中的起皱、拉裂、板料的厚度变化等。

To the question of wrinkle and drawing breakage during the rectangle box forming process, this paper describes the simulation of rectangle box deep drawing by Marc finite element analysis software.

针对矩形盒成形过程中各种形式的起皱和拉裂问题，采用MSC.Marc有限元分析软件对矩形盒深拉延成形过程进行模拟。

It can be concluded that the crack of skin is the macroscopic breakage form of grape and the maximal tensile stress is the main factor causing the mechanical damage of grape through comparing the model calculation with the experimental results.

经模型计算与试验结果相比较，得出表皮破裂是葡萄宏观破坏的主要形式，最大拉应力是造成葡萄机械损伤的主要原因。

Objective Observes the toxic response that the animal complete skin and the breakage skin contact disinfection drugs internal short-term.

目的观察动物完整皮肤及破损皮肤短期内接触消毒药品所产生的毒性反应。