axle的例句大全

Rolling bearing and its lubricating technology for railcars& axle bearing ( 1)

铁道车辆用滚动轴承及其润滑技术&车轴用轴承（1）

A axle of blast furnace charging wagon broke in use.

高炉上料车车轴在使用过程中发生断裂.

He is welding the pieces of a broken axle.

他正在焊接断了的车轴.

The truck axle added a lot weight to the vehicle.

卡车的车轴会给蝙蝠车增加很多总量.

A research has been made on 40 steel axle overheating.

研究了40钢车轴由于锻造加热不当造成的过热.

Position the lower suspension arm at the axle bracket and rear bracket.

把下端悬吊臂放在车轴支架和后侧支架上.

The garage mechanic found a crack in the back axle of the car.

汽车修理厂的机修工发现汽车的后车轴上有一条裂缝.

Frank abandoned his axle as the heat in it died.

由于车轴已经凉了,弗兰克扔下了它.

The Development Model ZZY& 10 Automobile Axle Load Scales

ZZY&10型汽车轴重仪的研制

Install rotor on axle hub.

在车轴轮毂上安装转子。

For surfacing welding the axle, steam valve blade of mixer and spiral carrying.

用于堆焊碳钢或合金钢的轴 、 过热蒸气阀们、搅拌机桨、螺旋输送机叶片的堆焊.

Remove the axle from a wheel so that it is not rideable.

取下一个轮子，以便它不骑乘桥。

The Manufacture of Large Type Bogie Hearth Furnace for Bulk Heat Treatment of HWM Wheel Axle in San Xia Engineering

三峡水轮机转轮整体热处理大型台车式炉建成

Analysis and treatment in site of the troubles resulting from axle box bearing failure

浅析由机车轴箱轴承损坏引发的故障及其现场处理

According to the principle of economical and practical, this paper analyses the reason of leaking oil around main axle bearing adopting technology reforming method can obtain good effect.

本着经济实用的原则，对X62W铣床主轴前后轴承漏油原因进行分析，并采取改进措施对其进行治理，效果良好。

New rise and descent systems were designed. After slip column and slip sleeve were substituted for axle bearing and orbit, failure vanished, utilization ratio of equipment and quality of products were raised.

经分析研究，发现故障产生的原因是结构不合理，通过重新设计计算，采用滑柱滑套结构替代原轴承和导轨条结构后，原有故障形式被消除，大大提高了设备利用率和产品质量。

Research and Application of the Axle Bearing Seal on Freight Cars

货车轴承密封的研究与应用

Cause Analysis and Countermeasures of Axle Bearing Crippling for Semi-lean Solution Pump

1107-JA半贫液泵断轴原因分析与对策

NKR Front Axle Assembly Line Rearrangement and Modification

NKR型汽车前桥装配线的重组与优化设计

The points for attention in designing the serration axle are pointed out.

指出了渐开线螺旋花键轴几何尺寸设计时应注意的问题。