beam的例句大全

Adaptive composite closed cell thin walled beam shape control

自适应复合材料薄壁梁形状控制

Effect of longitudinal distributed reinforcement on controlling the beam web cracking was evaluated.

分析了纵向分布钢筋对梁腹裂缝的影响；

A method for controlling beam intensity in MBE system by a nude gauge

MBE装置中分子束流的裸规控制法

Controlling beam halo-chaos using wavelet function feedback method

小波函数反馈法实现对强流束晕混沌的有效控制

Simulation Investigation on Controlling Beam Halo-Chaos Using the Information of Particles in Small Regions

以局部区域内的离子数为探测信息的束晕&混沌控制模拟研究

The Determination of Damp Absorber Parameters in Controlling Beam Resonant Response

阻尼吸振器在抑制梁共振响应应用中的参数选择研究

Study and analysis are made on premature breakage on the cross beam of vibratory screen produced with licensed technology.

对采用引进技术生产的振动筛横梁出现早期断裂的现象作了研究分析；

The whistle goes at the end of the match. Multi-beam echo sounding measurements

比赛结束时哨声响了.多波束回声测深数据

An Efficient Approach for Reducing the Side Lobe Levels of Array-Fed Reflector Satellite Shaped-Beam Antennas

卫星阵馈反射面赋形波束天线的一种高效旁瓣抑制方法

The tungsten oxide films with catalyst by two methods were characterized by X-diffractometer, tunnel scan-atomic force microscope, FT-IR, double-beam UV-VIS-NIR spectrophotometer and speediness volt-ampere cycle meter.

本文分别用X衍射仪、隧道-原子力显微镜、傅立叶变换红外光谱仪、双束紫外可见分光光度计、快速伏安循环法等表征了用以上两种方法制备的三氧化钨掺杂薄膜。

Brazing flux influence on processing properties of light beam brazing

钎剂成分对光束钎焊工艺性的影响

Electron beam brazing temperature field PID control system

电子束钎焊温度场PID控制系统

Analysis of the microstructure of the electron beam brazed joint

电子束钎焊接头组织分析

Application of Intelligent Instrument in Beam Bending Normal Stress Experiment

智能仪表在直梁弯曲正应力实验中的应用

Dynamics analysis of main beam stress in container bridge crane

集装箱桥式起重机主梁应力的动力学分析

The article introduces the technical gist of the construction control of the fish-bellied concrete continuous box beam.

该文介绍了鱼腹式混凝土连续箱梁的施工控制技术要点。

The fracture toughness K IC and interphase energy G IC of Ag-Cu/ Ti nan'on bilayer film and Ti monolayer film composite system are tested by unilateral gap three-point bend method and double cantilever beam method.

用单边缺口三点弯曲法和双悬臂梁法分别测试了Ag-Cu/Ti纳米双层膜及Ti单层膜复合体系的界面断裂韧性KIC及界面断裂能GIC。

Calculation on Large Deflection of Beam Bending Using Numerical Integral Method

计算梁大挠度变形的数值积分法

Testing method for annealing point and strain point of glass by beam bending

玻璃退火点和软化点测定方法-压梁法

It firstly derivates theoretical analysis formula of force and stroke by using beam bending theory and energy method.

首次采用梁的弯曲理论和能量法结合的方法推导了弯曲力和行程的理论解析公式。