bearings的例句大全

This paper describes the definition and function of free spread of auto engine main bearings;

本文叙述了汽车发动机曲轴轴瓦的扩张量含义和作用。

The mechanical fault of some large motor bearings are detected and analyzed, the corresponding improvement is proposed.

通过对某大型电动机轴承的故障检测及分析，提出了相应改进措施。

An investigation of warning of temperature increase of traction motor bearings for DF_11 locomotives A study of motor idling and bearing temperature increase

关于东风11型机车牵引电动机轴承温升报警的调查分析

Failure Mechanism of Motor Bearings in the Frequency Conversion Driving System

变频电机轴承失效机理分析

Study on Fault Diagnosis of Motor Bearings Based on EMD

基于EMD的电机轴承故障识别研究

Lubrication and lifespan analysis for key equipment motor bearings in nuclear power plant

核电站关键设备电机轴承润滑与寿命分析

Accident Analysis about Deterioration of Motor Bearings Bush of Boiler Feed Pump

锅炉给水泵电机轴瓦烧瓦事故分析

Causal Analysis of Broken Motor Bearings by Inappropriate Repairing Technique

修复工艺不当引起电机断轴的原因分析

It is used for long term protection and rust prevention of bearings.

适用于各种轴承的长期封存防锈.

The rear swingarm is supported on large pivot bearings, and it felt satisfyingly firm and rigid.

后叉部分则以大型转轴培林与主车架连结, 感觉相当的牢固.

Use of high-precision gears and bearings, high precision machine drive, smooth running.

采用高精度齿轮和轴承, 机器传动精度高, 运转平稳.

Their high-grade balls ensure smooth running and reduced noise compared to conventional deep groove ball bearings.

其高品位球确保顺利运行和降低噪声的常规相比,深沟球轴承.

UNC Zinc Plated Bolt , 2 X Self Lubricating Acetal Journal Bearings, Tread is mechanical interlock to hub.

不C锌镀金的门闩,2X自己的润滑缩荃日记举止, 踏是对毂的机械互锁.

Three-dimensional modal, stress distribution and harmonic response laws of water-lubricated bearings were studied using element software.

利用有限元软件研究了水润滑轴承的三维模态及其应力分布和谐响应规律.

In this paPer, nonlinear dynamic characteristic and transient performance of thrust bearings are studied.

本文主要研究了推力轴承的非线性动特性和瞬态性能.

The dynamic coefficients of tilting pad guide bearings are derived with the help of finite-elements using pressure parameters partial differentiation.

本文采用有限元法，利用压力参数法和偏导数法直接推求分块可倾瓦导轴承的动力特性系数。

Selection of Carburizing Steel for Rolling Mill Bearings and Design of Carburized Layer

轧机轴承渗碳钢的选择和渗碳层的设计

Front A rotation on balls bearings and needles, hydraulic clamping on crown type, reached and maintained position sensors, hydraulic control, control as M Function. roller for self-opening thread rolling head

A面采用滚珠滚针轴承，冠状液压夹具，维修定位传感器，液压系统。滚压式板牙头用圆滚子

The virtual contact loading method was further developed to study the load distribution in the axlebox bearings for locomotives.

本文将虚拟接触载荷法进一步推广应用到机车轴箱轴承载荷分布的研究。

Low-error gyroscope spin axis bearings often contain insufficient lubricant quantity to form full EHD films.

低误差的陀螺仪旋转轴轴承所使用的润滑油往往用量不足,不能形成足够的ehd油膜.