cooling的例句大全

The high carbon steel wires could fulfill the transformation to pearlite in the 0.25% CMC aqueous solution. But the transformation temperature is higher than that in lead patenting due to its attribution of continuous cooling transformation.

高碳钢钢丝在0.25%CMC水溶液中可完全转变为珠光体组织，但其转变温度由于其连续冷却转变特性而高于在铅浴中的转变温度。

To harden ( a metallic surface) by rapid cooling. The fitting is vertical to allow for free draining with straight run after quench oil injection for good mixing.

冷铸，冷淬通过急冷处理使（金属表面）变硬急冷器是立式的，以便急冷油注入后经直管自排，以达到良好的混合。

As there is no need to discharge the brine to sea from cooling tower, the ecological impact on ocean is eliminated.

海水冷却塔无需向大海排出部分浓缩海水，完全杜绝了给海洋造成的热污染和生态影响。

The barrel adopts far infrared heating and cooling devices.

机筒设有加热及冷却装置.

When the weather turns humid , give the back, arms and legs adustinga silky smooth cooling effect.

在天气变得潮湿时使用, 手臂,脚部会感到丝般光滑清凉感觉.

Numerical Simulation of Effect of Laminar Cooling Patterns on Plate Temperature Field

层流冷却方式对中厚板温度场影响的数值模拟

The overheated steam for cooling lubricants clean, no harm, the source of widespread, is completely green.

而过热水蒸气作冷却润滑剂无污染、无危害、来源广泛，是完全绿色的。

Conveyor, sterilization machine, cooling machine wind ( drying ) machine do the whole flow continuous operation, automatic control.

输送机 、 杀菌机 、 冷却机和风 ( 烘 ) 干机整个流程连续运行, 自动控制.

This paper describes the methods of fan testing and making fan property curve by dimensionless characteristic coefficient for the cooling fan of air-cooled engines.

论述了风冷发动机冷却风扇的试验法和用无因次特性系数法制取风扇特性曲线的方法。

When distilling sea water the cooling water discharging from the distiller is fed back to evaporator as feed water.

当蒸馏海水时，蒸馏器排出的冷却水返回蒸发器作为给水，其目的是为了提高经济性，选C。

The RTP temperature, the RTP time, the cooling rate, the ambient and the dopant atoms influenced the density and distribution of point defects in wafers, and then affected oxygen precipitates.

快速热处理温度、时间、降温速度、退火气氛、掺杂原子等都对硅片中点缺陷的形成及分布产生影响，进而影响氧沉淀的形成。

The effects of donor doping amount, cooling conditions after sintering and oxidation temperatures on the semiconductivity of SrTiO_3 have been studied.

研究了施主掺杂量，烧成后的冷却条件、氧化温度对SrTiO3半导化的影响。

Main points of the dosing system design of industrial circulating cooling water treatment

工业循环冷却水处理加药系统设计要点

Design of frost proof, air ducting and noise reduction for reverse-flow natural draft cooling tower

逆流式自然通风冷却塔防冻导风降噪设计

Through the theoretical analysis of the heat conduction process of water in the calorimeter in comparison with experiments, the paper confirms that Newton's law of cooling should be used to correct the value of the final temperature of water.

本文通过对量热器中水的传热过程的理论分析和实验比较，证明应该用牛顿冷却定律修正量热器中水的终温。

The Determination of Efficiency of QFS-300-2 Turbogenerator with Direct Water-cooling by Calorimetric Test

应用量热法测量QFS-300-2型双水内冷汽轮发电机的效率

Theoretical examination of cooling correction formula in bomb calorimetry and guidelines for establishing the best formula

氧弹量热法中冷却校正公式的理论探讨和建立最佳校正公式的准则

The experimental results indicated that the crystallization rate increased by increasing interaction between PVDF and diluent or increasing the cooling rate.

实验结果表明结晶速率随着聚合物与稀释剂之间的相互作用的减小或者冷却速率的增大而增大。

In hot runner mold, The exit of cooling water shouldn't at the top of mold.

热流道生产模型的运水出口不要朝上方.

Remove serpentine drive belt, refer to Group Cooling.

拆下蛇型驱动皮带, 请参阅单元7-冷却.