electrometer的例句大全

The guard terminal of the electrometer ammeter or picoammeter is the LO input terminal.

静电计安培计和皮安计的保护端为LO输入端.

More information on the measurement procedure can be found in the instruction manual of the electrometer.

有关测量方法的更详细的信息可以在静电计的操作手册中找到.

That's because when zero check is enabled, the input resistance of the electrometer is about 10 M ω.

这是因为当零点检查功能打开时, 静电计的输入电阻大约为10Mω.

This can be checked by observing the analog output of the electrometer or picoammeter with oscilloscope.

用示波器观察静电计或皮安计的模拟输出,可以对此进行检查.

The ohmmeter uses an internal current source and electrometer voltmeter to make the measurement.

欧姆计使用内部的电流源和静电计电压表来进行测量.

I've smashed the electrometer.

我把静电计摔碎了.

Therefore, a voltmeter with high input resistance, such as an electrometer, is required.

所以需要使用具有高输入电阻的电压表, 例如静电计.

The Model 6517 A Electrometer has the Alternating Polarity Method built into a test sequence.

6517A型静电计与变换极性法已被做成一个现成的测试程序.

When using the electrometer ohmmeter, measurement accuracy can be affected by a variety of factors.

使用静电计欧姆计时, 测量准确度会受到各种因素的影响.

Usually, this method requires two instruments: a voltage source and a picoammeter or electrometer.

通常, 这种方法需要使用两台仪器: 一台电压源和一台皮安计或静电计.

The damping circuit may already be built into the electrometer or may be an external circuit.

衰减电路可以装在静电计的内部,也可以是一个外部电路.

Use an adapter to connect the BNC connector to the triax input of the electrometer.

用一个适配器把BNC连接器连到静电计的三同轴输入端.

Enabling the guard effectively reduces the cable and switch capacitance, thereby improving the electrometer's response time.

采用保护可有效降低电缆和开关电容, 从而改善静电计的响应时间.

Figure 1-26 is a block diagram of a typical digital electrometer.

图1-26为典型数字式静电计的方框图.其模拟部分与前面讨论的电路类似.

Figure 2-42 illustrates a clipped waveform taken from the 2 V analog output of an electrometer.

图 2-42 示出在静电计的2V模拟输出端观察到的限幅波形.

Figure 4-2 illustrates the basic circuit that uses an electrometer to determine dielectric absorption.

图 4-2 说明使用静电计确定介电吸收的基本电路.