heat-transfer的例句大全

Experimental Study of Flow and Heat Transfer of Narrow Annuli with Bilateral Heating

窄缝环形通道内单相液体传热和压降的实验研究

And the simplified analytical model can be used to analogically analyze the conductive-radiative coupled heat transfer in metal foams and the influencing mechanism of the various factors on the ETC.

本文提出的简化理论模型可用于类比分析泡沫金属内的导热-辐射耦合传热和各因素对有效导热系数的影响机制。

Algebraically explicit analytical solution for heat and mass transfer in wet porous media

含湿毛细多孔介质传热与传质基本方程的一组代数显式解析解

The main content of this paper was as follow: ( 1) Hydrodynamics and heat and mass transfer efficiency of SiC ceramic corrugated packing applied to air humidification process.

本文的主要内容有：（1）.SiC泡沫陶瓷波纹填料流体力学性能和传热传质性能研究。

Theoretical analysis and modeling of overall heat transfer of air handling unit by using spraying water

水&空气处理系统全热交换模型和性能分析

The heat and mass transfer in agitation tank are influenced significantly by the center big vortex.

搅拌反应釜中心的大旋涡对物料的传质传热有重大影响。

Analysis of film boiling heat transfer mechanism for solid particulate adulterate into cooling fluid

引入固体颗粒强化膜态沸腾换热的机理分析

Numerical study on adiabatic wall cooling effectiveness and convective heat transfer coefficient of effusion cooling

致密孔阵气膜冷却绝热温比和对流换热系数的数值研究

This paper reports the current studies on the film cooling characteristics of single-row holes on flat plate at different blowing ratios, and analyzes the distributions of adiabatic film cooling effectiveness and heat transfer coefficient downstream the film holes.

对不同吹风比条件下的典型单排孔冷却结构的平板气膜冷却特性进行了实验研究，对冷却孔下游的气膜冷却效率及换热系数分布规律进行了分析。

Heat transfer of condensation of multi constituent mixture on aculei tube

多组分混合物在犁刺管上强化传热研究

This paper researches into enhanced heat transfer of condensation of splitting gas of waste plastics and R113 on the general smooth tubes, the screw tubes and the aculei finned tubes.

本文研究制冷剂R113和废塑料制汽油过程中产生的裂解气在水平光滑管、螺纹管与“犁刺”管上的冷凝强化传热。

Transient Coupled Heat Transfer in a Three-Layer Absorbing Medium Composite with Semitransparent Interfaces

半透明界面下三层吸收性介质内的瞬态耦合换热

The presence or absence of clouds can have an important impact on heat transfer

有无云层对热量的传递会产生重要的影响。

Numerical studies are reported for three-dimensional steady-state natural convective heat transfer in inclined concentric annuli filled with liquid-saturated porous media, with either Dirichlet or Neumann boundary wall condition and both ends being insulated.

本文报道三维稳态、Dirichlet和Neumann两种边值条件下倾斜环形湿饱和多孔介质中自然对流的数值计算和实验检验的结果。

Based on the theory of heat transfer, radiation between fire and the steel structural member in indoor fire was analyzed, together with the convection conditions on the boundary of the member and the conduction model within it were also confirmed.

根据传热学原理，分析了室内火灾条件下火源与构件之间的辐射传热关系，讨论了构件边界对流换热条件以及确定了构件内部的导热模型。

The Radiant Heat Transfer Equation of the Mixing Burning Boiler Furnace of Grate and Pulverized Coal

链条炉炉膛加煤粉复合燃烧的辐射换热计算

Structure Design and Heat Transfer Analysis for the Cryostat

低温杜瓦装置的结构设计与传热分析

It is found that heat transfer coefficient increases with fin height, while flow resistance varies as concave curve, that is to say, the resistance reaches the lowest value at a middle fin height.

结果表明，随着流道内翅片高度的增大，传热膜系数随之增大，但流阻曲线则呈凹型变化，即在中间高度时流阻达到一最小值。

A General Correlation for Predicting Average Heat Transfer Coefficient of Film Condensation

计算冷凝平均膜传热系数的一个普遍关联式

New surface materials for dropwise condensation heat transfer of steam

实现水蒸汽滴状冷凝的表面材料研究