layer的例句大全

After high pressure jet and wash, cement grouting, the bedding fault zone in layer C5 and fractured fault zone were tested, checked and analyzed by supersonic wave.

C5层间错动带、断层破碎带经高压喷射冲洗水泥灌浆后，应用超声波测试检查和分析。

The result show that muscle trace Mercury Contents in fishes follow the Pattem: benthic fishes> upper-layer fishes;

结果表明，各种鱼类肌肉中汞含量的顺序为：底层鱼＞上层鱼；

Study on Distribution of Injected Carrier Densities in the I-Layer of a Forward Biased PIN Diode

PIN管正偏注入的载流子在Ⅰ层中分布的研究

Then the bidding rules based on the capacity and the adjustment of generation are presented, Furthermore, a method of congestion management, combined with the prize zone and the spot price, is introduced to be suited to the multi layer power market in future in China.

设计了基于容量报价和调整报价两种实时报价方法，给出了将区域电价和实时电价相结合的阻塞管理方法以适应我国未来的多级电力市场模式。

In the process of the calculation, the effect of the hull, the boundary layer and the bilge keel are taken into account.

计算过程中考虑了船体壁面、船体边界层的影响。

Moreover, sheet billet containing Cu, Ni will bring about a layer of viscous iron oxide scale when heated in soaking furnace that resulted in influence on the surface quality of steel product.

此外，含Ni、Cu合金元素板坯在均热炉内加热时会产生很粘的氧化铁皮，影响钢材表面质量。

These algorithms utilize the perception difference of human's ear to the different frequency signal and the spectrum difference between noise and recognition objects to compensate the effects of noise with maximum likelihood criteria and linear combination or discriminative combination or multi-layer perceptron.

这些方法利用人耳对不同频率信号感知的差异，以及噪声和识别对象的频域特征差异，分别采用线性分析、判决分析、多层感知机以及子带最大似然估计对噪声影响进行补偿。

Patients with pleural thickening, adhesion and encapsulation, visceral layer pleural biopsy by forceps pleural biopsy trocar is a kind of simple, safe and effective way.

具有胸膜增厚或胸膜粘连、胸水分隔包裹性胸腔积液患者，应用钳式胸膜活检套管针进行脏层胸膜活检是一种简单、安全和有效的胸膜活检方法。

Ion implantation technique for the fabrication of very high-speed bipolar circuits is discussed in the paper, with emphasis on the ion implantation doping and shallow junction formation and the annealing of the implanted layer in bipolar device process.

本文讨论了高速双极器件制造中的离子注入技术。重点讨论在双极器件制造工艺中的离子注入掺杂技术，离子注入形成浅结技术，以及离子注入层的退火技术。

The standard ATM Adaptation Layer 2 ( AAL2) which is designed to improve the bandwidth utilization for delay sensitive low bit rate traffic, has found wide applications to tactical ATM communication networks.

AAL2是为了满足对时延敏感的低速率或可变速率的短分组业务需求而提出的一种组合信元ATM适配技术，在战术通信网中也得到了应用。

Although the bituminous pavement of cement stable sandy foot layer has good effect in most engineering, it has partial craze of pavement, even with net-shaped crack distortion and structural destruction, which not only shorten the using age of road but also bring hidden trouble for safety.

水泥稳定砂砾基层沥青路面虽然在大部分工程使用中效果不错，但仍有局部路面开裂的问题，甚至发生网裂变形和结构性破坏，从而缩短了道路的使用寿命，也给行车安全带来隐患。

A three layer forward neural network is applied to predict the pulp bleaching effect, and to distinguish the kind of operating mode.

应用三层前向网络作为预测纸浆漂白效果的分类模型。

The results of tests indicated that that burning the granular coal blending fuel in layer combustion boilers can save fuel by over 10%, and reduce the dust emission by more than 60% compared with firing raw coal.

试验表明：层燃炉燃用粒煤燃料可节煤10%以上，烟尘排放减少60%以上。

Results are as follows: 1.According to slope structure types, the metamorphic rock slopes are divided into blocky structure slopes, layer structure slopes, cataclastic structure slopes, granular structure slopes and base structure slopes.

得出了如下成果：（1）将线路区变质岩边坡按坡体结构类型分为块状结构边坡、层状结构边坡、碎裂结构边坡、散体结构边坡和基座式结构边坡五大类。

Application of Dual& layer Fusion Bonded Epoxy Anticorrosion System in Gas Pipeline

天然气管道双层熔结环氧粉末防腐体系的应用

The EIS results of bonded coating indicate that three time constants were obtained during the initial immersion period, and then a new time constant appeared due to the formation of rust layer.

而对于有粘结层的涂层，其交流阻抗谱在浸泡初期具有3个时间常数，浸泡后期由于在碳钢表面生成了一层腐蚀产物，出现了1个新的时间常数。

Layer thickness analysis results from a bonding pad on a circuit board, showing nanometer resolution thickness analysis.

来自电路板结合区的厚度分析，纳米尺度的厚度分析。

TEM study of bonding layer in Cu-Al explosively welded joint

Cu－Al爆炸焊结合层的透射电镜研究

Technique, such as electronic probe, XRD, optical microscope, micro-hardness and macro hardness test, are applied to investigate the microstructure, phase structure, and analyze the alloy element distribution of metallurgical bonding layer and the material mechanical property changes.

利用电子探针、XRD、光学显微镜、显微硬度和宏观硬度测试等手段，研究扩散件试样的显微组织、物相结构，分析冶金结合层中合金元素分布和材料内部力学性能变化。

The capability variation rule of bonding layer was also analysed.

采用滑动磨损法检测了耐磨性，并分析了衬瓷层性能的变化规律。