modulus的例句大全

Experimental Achievement of Applied Load, Confirmation of Compressive Modulus Index of Subgrade Soil by Reversed Deduction Method

应用静载荷试验成果反演地基土压缩模量指标

It is clear that increases adherend thickness or Poisson ratio as well as decreases the elastic modulus may decrease the peck value of Von Mises equivalent stress.

分析可知：高的泊松比、低弹性模量和被粘物厚的增大会使得VON MISES等效应力值显著降低。

Inversion of Elastic Modulus of Thin Plate Using Acoustic Pressure Transmitting Coefficient Spectrum

应用超声声压透射系数谱反演薄板的弹性模量

Research on Testing the Quality of Rock Mass with Boring Elastic Modulus Instrument and Acoustic Wave Instrument

钻孔弹模计及声波仪检测岩体质量的试验研究

Study the toxic effect on rats 'absolute weight of organs and on the modulus of organ. Study the impact of DBP and DOP on male rats' sperm amount, activity, and the rate of survival.

对小鼠脏器的绝对重量及脏器系数的的毒性作用以及DBP和DOP对雄性小鼠精子数量、活动率、存活率的影响。

The results showed that the critical fracture load of passive films reduced and the displacement excursion decreased with increasing the concentration of hydrogen. The reduction of radial breaking stress and elastic modulus of passive films is attributed to that hydrogen changes the structure of passive films.

结果表明：随氢含量的增加，不锈钢钝化膜的临界破裂载荷降低，位移偏移量减小，氢导致钝化膜的径向抗拉强度（应力）和弹性模量降低，钝化膜随氢含量的增加而逐渐软化。

Parametric studies show that the axial elastic modulus of the composites increases with increasing the linear density ratio of axial yarn to braider yarns and pitch length.

参数分析结果表明，轴向弹性模量随轴纱与编织纱线密度之比和节距长度的增加呈增加趋势。

Evaluation for Relaxation Modulus and Creep Compliance from Stress Relaxation Test Data

由应力松弛试验数据确定松弛模量和蠕变柔量

The results obtained from relaxation modulus show good agreement with experimental data of creep compliance.

结果表明：由松弛模量计算蠕变柔量的理论值与实验值吻合；

The characteristic of interatomic forces in these two phases, the nature of bulk modulus and compressibility at Neel temperature, and the order of phase transition of cobalt oxide are discussed based on the experimental results.

根据实验数据对CoO两相中原子相互作用力性质，在Nel点的体弹模量B5和压缩率βr特性，以及CoO磁性相变的级数等进行了讨论。

It elicits the relationship among the PU strips 'compressive strength, compressive modulus and rigidity by testing many kinds of PU strips' capability.

测试了多种PU弹垫的性能，得出PU弹垫的压缩模量、压缩强度与硬度的关系。

To enhance thermal-wear resistance of the mandrel, it is required to use mandrel material which has dispersed carbide, linear expansion factor of the base metal close to that of the chide film, minimum elastic modulus and maximum thermal conductivity factor.

为了提高芯棒的抗热损伤性能，应使芯棒材料的碳化物弥散化，基体金属与氧化膜的线胀系数相接近，弹性模量尽量低，热传导系数尽量高。

It has been proved by the investigation that the filling effect of the confined expansion makes the reduction of holes in concrete as well as the increase of strength and elastic modulus of concrete.

实验证明：由于约束膨胀的填充作用，大幅度降低空隙率及孔径，定将有效地提高混凝土的弹性模量及强度。

Properties of n-th completely linear subgroup on modulus of congruence class ring

模m同余类环生成的n阶完全线性子群的阶的计算

The paper presented the definition and properties of n-th completely linear subgroup on modulus of congruence class ring, and calculated the formula of factorial.

文中给出了模m的同余类环上的n阶完全线性子群的定义及性质，利用子群进行分类，通过陪集的计数定理，给出了其阶的计算公式。

Meanwhile, the influences of lime dosage ratio, consolidation ratio, and frequency on elastic modulus were investigated.

同时还针对掺灰比、固结比以及频率等影响因素进行了深入研究，得出了下列的结论：石灰土的动弹模量随应变水平的变化规律与粘土基本一致；

Based on tensile testing for different width specimens of geotextiles, the relationship between specimen width and breaking strength, breaking elongation, lateral contraction, strength of fixed elongation and elasticity modulus were analyzed.

通过对土工织物不同宽度的拉伸试验，分析了土工织物试样宽度与断裂强度、断裂伸长率、侧向收缩率、定伸长强度、弹性模量之间的关系。

Convex modulus depicted overall degree of convexity of the unit sphere of spaces. It was very different for degree of convexity of each point that it would produce very great influence on the whole feature of the spaces.

凸性模刻划了空间单位球面的总体凸性程度，但是每一点的凸性程度都有很大的不同，这将会对空间的整体性质产生很大影响。

Scissors Model Error of Oedometer Index and Its Correction by Chord Modulus

Oedometer试验指标的剪刀型错误及用弦线模量的改正

Cell-size has a significant effect not only on the crushing stress and plastic modulus of aluminum foam, but also on the strain-rate sensitivity of material of this kind.

泡孔尺寸不仅影响着材料的屈服强度和塑性模量等，还影响着材料的应变率敏感性。