rail的例句大全

A new electronically controlled common rail fuel injection system is introduced.

介绍了一种新的电控共轨式燃油喷射系统.

Rail links entry of a manual, electric, dual-use flashlight, petrol-driven models, and so on.

轨链拆装机有手动 、 电动 、 手电两用 、 汽油机驱动等机型.

The structure of diversion rail cylinder former , the major design parameters and application effect were discussed.

本文介绍了导流栅片圆网成形器的结构及主要设计参数的选择依据.

A BRT system has the same properties as a rail-bound system when it comes to passenger capacity and average speed.

快速公交系统的载客量和平均时速指标不逊于轨道交通系统。

All shipments of compressed oxygen must comply with DOT regulations. This applies to motor freight, rail, air, and water shipments.

所有压缩氧的运输必须遵守DOT的规定。这对汽车货运、铁路、空运和水运都有效。

This paper analyzes the cause of producing small concave around weld seam according to practice of welding long rail in Guangzhou Metro Line 2, and presents the preventable measure to overcome.

本文结合广州地铁二号线接触焊焊接长钢轨实践，分析了焊缝热影响区产生轨面小凹痕的原因，提出克服此类缺陷的预防措施，可供类似工程借鉴。

Asian countries are expected to spend over$ 200bn on mass transit rail systems in the next decade to combat rising urban congestion.

预计未来10年亚洲国家将会在公共轨道交通系统上投入2000亿美元，以抗击日益加剧的城市拥堵问题。

The side slip angle, cornering force, aligning torque and cornering potential energy of the pneumatic tires were deduced. And the spring deformation energy and damping-force potential energy of the wheel-rail radial contact were also deduced. 4.

推导了充气轮胎的侧偏角、侧偏力、回正力矩和侧偏势能，也推导出了承重轮、导向轮的轮轨接触弹簧变形能和粘性阻尼力势能。

The results showed that capillary crack was formed from the surface cavity of billet in the process of high temperature heating-rolling and cavity and sliver defects were formed due to part melting of seating face of heavy rail.

分析结果表明：发纹缺陷是由方坯表面气孔经高温加热-轧制演变成的，掉肉和小裂口则是因重轨踏面局部融熔所造成的。

For concrete faced rockfill dam, the slope of upstream and downstream is generally 1:1.3& 1: 1.7.The no-rail slip-form construction technology for facing concrete has been a ripe technological measure.

对于混凝土面板堆石坝而言，堆石坝上下游坡比一般在1∶1.3~1∶1.7之间，其面板混凝土采用无轨滑模施工已是相当成熟的一项技术措施了。

The Effects of Train Braking and Ballast Resistance on the Longitudinal Force in Rail

列车制动与道床阻力对钢轨纵向力的影响分析

By many years experiences, controlling ballast resistance and excessive compressive temperature force of the rail is recognized as the only means to overcome the track buckling.

多年来认为控制道床阻力及钢轨内的温度力是防止胀轨跑道的主要办法。

But in fact, due to the great variation of ballast resistance during track work and change of "stress free temperature" of the rail, they are hard to measure then hard to control.

但道床阻力在作业时变化很大，钢轨在线路上长期使用，锁定轨温可能发生变化，温度力亦不易控制。

Study on the Distribution of Longitudinal Temperature Stress along Welded Continuous Rail on the Solid Ballast

整体道床无缝轨道纵向温度力分布规律研究

Introduction of shield running tunnel emergency repair of Shanghai rail rapid transit Line 9

上海轨道交通9号线盾构区间隧道抢险修复工程介绍

Home Manufacture Scheme of AC Drive Inverter System in Beijing Urban Rail Traffic

城市轨道交通交流传动逆变器系统国产化方案

The wear value is real-time displaying on the measurement software interface, and we can also view the current processed rail curve.

处理后的磨耗值实时显示在测量软件界面上，并能查看当前点处理后的钢轨轮廓曲线。

Finite Element Analysis of Prestressed Reinforced Concrete Light Rail Bridge

预应力钢筋混凝土轻轨桥梁的有限元分析

Development of Bogies for Low Floor Light Rail Vehicles in Japan

日本低地板轻轨车辆转向架的研制

Acceptance Test of Port land Low Floor Light Rail Cars

波特兰低地板轻轨车辆的验收试验