shaft的例句大全

Install the straps and bolts to hold the propeller shaft to the yoke.

安装扣夹和螺栓,将传动轴固定到轴轭上.

Remove the rear propeller shaft.

拆卸后传动轴.

In the mill shaft coupling, its external gear set also often uses the circular arc drum-shaped gear.

例如，在轧钢机联轴器中，其外齿套往往采用圆弧鼓形齿轮。

Likewised, should the mechanical shaft seal assembly require replacement, the gear set dose not have to be removed from the pump.

同样地，机械密封轴部件取代，不需要从泵体上移除。

There is 2 CY gear pump series pump body, cover, gears, bearings and the shaft sealing etc.

2CY系列齿轮油泵是有泵体 、 泵盖 、 齿轮 、 轴承套以及轴端密封等零部件组成.

The shaft seal can adopt soft gland packing or mechanical seal for selection.

泵的轴封有软填料和机械密封两种供用户选用.

Shaft seal: it can use mechanical seal, dynamic seal and packing seal, at theoption of users.

轴封: 采用机械密封 、 动力密封及填料密封, 用户可以任意选定.

The shaft seals use quality mechanical seal.

采用加长轴电机直联结构,轴封采用优质机械密封.

Field test study of methods for supporting large-section inclined shaft in gravel layer

卵砾石层大断面斜井井筒支护方法现场试验研究

Investigation on the shaft neck fatigue crack of helicopter rotor hub

直升机旋翼桨毂轴颈疲劳裂纹探讨

Mine shaft hoist system accidents occur occasionally, causing casualties, while also caused damage of the equipment, the duration of the delay or interruption of production, seriously affected the normal conduct of the mine production activities.

矿山竖井提升系统事故时有发生，造成人员伤亡的同时，也造成了设备的损毁、工期的延误或生产的中断，严重影响了矿山生产活动的正常进行。

Design and Construction of Big-calibre Bench Mark of Shaft Type

大口径竖井式基岩水准标设计与施工

The bearing inner races were a tight fit to the table shaft.

轴承的内圈与台轴采用紧配合.

Dilatable Bone Nail Applied in 17 Cases of Humerus Shaft Fracture

可膨胀髓内钉在17例肱骨干骨折中的应用

To observe the clinical effect of dilatable bone nail on humerus shaft fracture.

探讨可膨胀自锁髓内钉治疗肱骨干骨折的临床疗效。

The application of all solutions and algorithms were illustrated with a typical shaft-like parts drawing.

以轴类零件图为例,详细分析了作业图批改的若干关键技术,并给出了相应的算法和程序流程图.

This paper briefly describes the new shaft type scrap preheating system called UL BA developed by Japanese Nippon Steel Corporation.

文章简要介绍了日本新日铁开发的新型竖炉式废钢预热系统，即：UL-BA方式预热装置。

One end of the central axis connects the output shaft of the driving device.

中轴一端与动力机构的输出轴相接.

Installation of software of No 1 Military Project for client and its maintenance Installation of Shaft

军字一号客户端软件系统的安装及客户端维护竖井井筒装备一次成型

Strong load capacity of shaft , service life long.

轴载荷能力强, 工作寿命长.