shaft的例句大全

The steering wheel is mounted on a steering shaft that extends into the steering gear.

转向盘安装在转向轴上,转向轴延伸至转向器.

Commonly used shaft steelwork styles are compared inpaper the right scheme applying rail steelworks is adopted.

本文通过比较立井提升常用罐道型式的优缺点,确定了采用刚性组合罐道的改造方案.

Excessive amount of grease applied to the input shaft splines.

涂抹过量黄油于输入轴齿槽中.

Turn the shaft, if the clutch-disk hub splines. Put Bolts in place , and tighten correct tension.

如果与离合器 从动 盘轮彀的花键相连,可转动传动轴, 把螺栓就位, 并适度拧紧.

The friction disk is splined to the clutch shaft.

带有摩擦衬片的圆盘,通过花键与离合器轴相连.

The spirally threaded shaft of a worm gear.

螺纹''.'蜗'. ''轮的刻有螺旋线的柄.

Slotted on shaft end, suitable for DC motor and servo motor.

轴头开槽, 适用于直流电机,伺服电机.

By using this fixture, the slimness shaft with any length can be machined.

使用该夹具可切削加工任意长度的细长轴.

Unclamp the shaft from the vise and slide off the top bearing.

松开老虎钳上的轴,将顶部轴承移出.

That thick shaft that causes women to shudder.

那个粗大的柱子让女人都颤抖.

The shredding chamber is a combined structure and the cutter shaft adopts rolling bearings and maintenance.

破碎室采用组合式结构,刀轴采用滚动轴承支承,装卸维修方便.

Disconnect the axle or end of the propeller shaft or the universal joint, according to type.

根据变速器的类型,拆下后桥或者传动轴或者万向节.

Penetrating Tint: A tint which penetrates into hair shaft and deposits color permanently.

渗透性染料: 一种可以渗透进发杆内部永久显色的染料.

The dynamic unbalance of blower shaft can be eliminated to adopt double surface dynamic balance method.

采用现场双面动平衡技术消除了风机转轴动不平衡.

Objective To treat femur shaft fracture with U-shaped plate.

目的探讨U形接骨板固定治疗股骨干骨折的疗效.

Ride the train to the ventilation shaft.

乘火车到达通风井找到柱状物体.

This text introduces the application of theodolite in the directional measure technique in Qidong ventilation shaft.

简要介绍了陀螺经纬仪在定向测量中的应用和祁东风井联系测量技术.

Because ventilating requirement cross-ocean tunnel, expecially distance cross-ocean tunnel, ventilating shaft should be set at sea.

跨 海隧道, 特别是长距离 跨 海隧道, 由于隧道内通风的要求,必须在隧道中间即海中设置通风竖井.

[不可数名词]a ventilation shaft

通风井

Varus malreduction was defined as a head-shaft angle of < 120 degrees.

内翻复位不良按头 - 干角<120度为标准.