solids的例句大全

It links the spectroscopic, structural, mechanical, and electrical properties of solids.

摩擦发光起因于固体力学能量应用的光发射, 与固体的光谱结构 、 学和电学性质相联系.

...the decomposition of solids.

固体的分解

Certain granular solids transform into highly mobile slurries.

一定数量的粒状固体就可以变成非常易流动的泥浆.

The still sketchy theory of luminescence in solids and liquids cannot be discussed here in detail.

在此不能详细讨论目前还很粗糙的固体和液体的发光理论.

Underground erosion is the removal of solids, from the soil by the flow of underground water.

地下侵蚀是指固体颗粒被地下水流从土壤中带走的现象.

VOC Does not contain . It is a 100 % solids epoxy product.

挥发性有机化合物无, 100%固含量环氧产品.

Disk valves are commonly used when solids are in the aerated state.

蝶阀通常用在固体处于充气状态的地方.

Decreases white water solids to improve raw material yield and save all efficiency.

减少白色固体水,提高原料产量,及释放最大效率.

There are two kinds of elastic waves in solids a compressional wave and a transverse wave.

在固体中有两类弹性波,一类是压缩波,另一类是横波.

When a kiln rotates, the thermocouple periodically contacts feed solids materials.

因窑炉转动 、 物料和热电偶周期接触,引起测量温度周期性变化.

To counter the reduction in thermal efficiency, heat can be recovered from the discharged dried solids.

为了弥补热效率的降低, 热量可以从排出的干燥固体颗粒中加以回收.

On the contrary, beds of large uniformly sized solids often fluidize poorly with bumping, spouting and slugging.

相反，均匀大颗粒床层常常由于碰撞、喷射和腾涌而流化不好。

Seawater is pure water plus dissolved solids and gases.

海水里面溶解着固体和气体.

When dissolved gases and solids mix with pure water.

当净水和可溶解的气体与固体混合时.

Spatial distribution of backscattered electrons in solids by Monte Carlo simulation

Monte Carlo方法计算背散射电子在固体中的空间分布

Pericarp changed from green to light red, finally to faint red or mauve, soluble solids increased rapidly, acidity increased first and then decreased and water content increased when pitaya fruit became mature. 3.

火龙果在成熟期时，果皮由绿转至浅红，最后转至淡红或紫红色；可溶性固形物迅速增高，酸度升高后下降；水分含量增加。

As a general rule, solids expand as the temperature increases and contract when they are cooled.

一般来说, 固体热胀冷缩.

Skewed symmetry detection of quadric surface solids under orthographic projection exploration of CAI in engineering drawing& to analyse the trend of intersecting lines of two stereoscopic cambers

正交投影二次曲面立体图的斜置对称面检测（英文）工程图学中计算机辅助教学探索&两曲面立体相交趋势分析

Internal friction behavior of the standard anelastic solids in low frequency

低频内耗测量时标准滞弹性固体的内耗行为

The Mathematical Methods of Several Typical and Common Solids Surface Faired Curve View

几种典型立体表面展开图的数学方法