stress的例句大全

Allowing the thigh to point down at an angle may make it easier to maintain an inward curve in your lower back, which is suggested to reduce low back stress.

让大腿以某个角度向下倾，可以更容易地让下背保持向内弯曲的姿态，据说这样能缓解下背部压力。

Under laboratory conditions, after calcined at the temperature of 700 ℃, red-mud is mixed with cement to produce a special kind of concrete, with which the standard concrete is compared in terms of breaking and stress intensity.

在实验室条件下，对赤泥进行700℃的煅烧处理，并利用其制取水泥赤泥混凝土，与基准混凝土的抗折、抗压强度进行对比。

The results showed that the critical fracture load of passive films reduced and the displacement excursion decreased with increasing the concentration of hydrogen. The reduction of radial breaking stress and elastic modulus of passive films is attributed to that hydrogen changes the structure of passive films.

结果表明：随氢含量的增加，不锈钢钝化膜的临界破裂载荷降低，位移偏移量减小，氢导致钝化膜的径向抗拉强度（应力）和弹性模量降低，钝化膜随氢含量的增加而逐渐软化。

It was found that the breaking stress decreased with decrease of molecular weight and degree of macromolecular orientation. The exPeriment show that the macromolecular orientation degree 0f the new material varies with silk reeling pmeesses;

对于采用不同缫制加工工艺制得的各种真丝新材料，其材料中大分子取向程度亦不相同。

It was found that the breaking stress decreased with decrease of molecular weight and degree of macromolecular orientation.

研究结果表明，本文工艺条件下研制的PDS缝线在体外降解过程中随着分子量和大分子取向程度下降，力学性能明显下降，4星期时强度基本消失。

Based on the studies above, the prediction models of breaking stress and breaking elongation are explored primarily.

基于上述对浆纱耐磨性和浆纱结构的研究，对浆纱断裂强力和断裂伸长率预测模型进行了初步的探索和研究。

Through theoretical analysis and experimental measurements, the distribution of local bearing stress in brick masonry under beam support and the position of its resultant have been determined and the load eccentricity can also be determined therefrom.

通过理论分析和试验实测得出梁端局任应力分布及其合力作用点的位置，由此可以确定由梁端传给墙体荷载的偏心距。

Especially, we stress that our government should encourage the spontaneous brokage in the country of China, and provide protection for it.

行文之中，作者特别强调了要鼓励与保护全国各地正在自发形成的农村经纪行业。

Studied on the Seed Vigor and Drought Resistance of Three Perennial Forages Belong to Bromus under PEG Stress

雀麦属3种多年生牧草在PEG胁迫下种子活力与抗旱性研究

Bubble Chamber Stress Analysis of the Bonding Container in Continuous Extrusion Forming

连续挤压模具型腔焊合室应力分析

Stress Analysis of the Dental Surrounding Tissues of Different Degree Tilted Abutments and the Effects of Different Buccolingual Diameter of Pontic to the Abutment Periodontium: Three-dimensional Finite Element Analyses

不同角度的倾斜基牙以及桥体的不同程度颊舌减径对固定修复后基牙牙周受力影响的三维有限元研究

The influence of inclusion on crack Stress Intensity Factor ( SIF) of Powder Metallurgy ( PM) FGH 95 was investigated using singular element method with fine mesh at crack front.

采用有限元方法中的奇异单元，研究了当粉末高温合金FGH95中存在由夹杂引起的裂纹时，夹杂对裂纹应力强度因子的影响；

Analysis of stress and strain in round hole burring process

圆孔翻边应力应变分析

Research on Contact Stress Field of API Buttress Casing Thread Connection

API偏梯形套管螺纹连接的接触应力场研究

Treatment with Tong Xin Luo Capsule, however, both adhesion force and adhesion stress were markedly reduced ( P < 0.05 or P < 0.01).

加通心络胶囊后，细胞粘附力和粘附应力均明显下降（P<0.05或P<0.01）。

The results show that the acumination of the particle can result in stress concentration of the particle tip and strain concentration in the matrix.

结果表明，颗粒尖锐化会导致颗粒尖端应力集中和基体内的应变集中。

The Sensitivity of Adaxial and Abaxial Stomatal Resistance in Wheat Leaf to Soil Water Stress

冬小麦近轴和远轴叶面气孔对土壤水分胁迫反应的敏感性

The stress and strain distributions in the gluing joint are considerably influenced by some factors such as the geometry of the adherend, the lap length and the adhesive thickness etc.

胶接接头中应力应变分布的具体情况取决于被粘物的几何尺寸、搭接长度以及胶层厚度等因素。

It is clear that increases adherend thickness or Poisson ratio as well as decreases the elastic modulus may decrease the peck value of Von Mises equivalent stress.

分析可知：高的泊松比、低弹性模量和被粘物厚的增大会使得VON MISES等效应力值显著降低。

Study and Measurement of Adhesion Strength and Film Stress of Ag-Cu/ Ti Substrate Bilayer Films Composite Systems

Ag-Cu/Ti双金属膜结合强度及应力研究