冷却的例句大全

The reheating furnace for rolling employ water for cooling furnace door, akid pipe and so on.

加热轧件的加热炉用还来冷却炉门和滑道管等.

Process, quench and rotate parts as per Stand Operation Procedure.

根据标准操作流程加工 、 冷却、循环产品.

Firstly, high quenching temperature caused overheating. Secondly, the quench cooling process is too rapid.

产生淬火裂纹的原因一是由于淬火温度过高,引起组织过热,二是淬火冷却过快.

Rio Tinto had recently cooled on Chinalco's planned investment in the group – leaving ruffled feathers.

此前不久,力拓对于中铝投资计划的热情有所冷却——这成为了一个过结.

Rubber bands last longer when refrigerated.

橡胶带冷却时会更耐用.

After reflow soldering and restored at room temperature , they meet the characteristics listed below.

经过回流焊并冷却至室温后,电容器的特性符合下表的要求.

Plastic film to come out the oven and roll by cooling loop in the same group.

塑膜从烘箱出来通过冷却辊而进入下一色组.

The gas Roaster are cooled, and then put into absorption tower to form regenerative acid.

产生的气体冷却后进入到吸收塔形成再生酸.

Direction of connection for RMB and RMF coolant is different.

RMB与 rmf之冷却剂连接方向不同.

In cooling, the rivet contracts.

铆钉在冷却时会收缩.

It was the very best of watercoolers, up-to-date, scientific, and right-thinking.

它是最好的饮水冷却器, 新颖 、 科学 、 设计合理.

Enough excess to create an uneven stacking while winding the coil on the rewind.

卷取机卷取带卷时,过量冷却液造成卷料不齐平.

A pilot study on the reuse of circulating cooling sewage from plants has been carried out.

针对电厂循环冷却排污水的处理技术进行了中试研究.

So the problem of unfavorable effect of ammonia nitrogen in wastewater reuse has been solved.

利用循环冷却水系统不需增加费用就可以脱除污水中氨氮,从而消除了污水回用中氨氮的影响.

The reheating furnace for rolling employs water for cooling furnace door, skied pipes and so on.

加热轧件的加热炉用水来冷却炉门和滑道管等.

Rear-wheel drive cars with longitudinal engines usually have engine-driven cooling fans.

发动机纵置的后 轮驱动 车通常配备有发动机自身驱动的冷却风扇.

Lime process is an important technology for reuse of urban reclaimed wastewater in recirculating cooling system.

石灰法是城市污水再生回用于工业循环冷却系统的重要技术.

Scheme 1 : whole set of equipment is cooled by purified recirculated water of factory.

方案 一: 成套设备采用工厂净环水冷却.

The oil is cooled and recirculated in the scrubbing towers.

油经冷却并在洗涤塔中循环使用.

The cooled water then reenters the engine, where it can pick up more heat.

冷却后的水又重新进入发动机, 再把发动机中的热量传导出去.