刚度的例句大全

The fourth-rank tensors contain the compliance and stiffness constants.

四秩张量包含柔量常数和刚度常数.

Ribs are sometimes add to the webs of castings to give greater strength and rigidity.

有时在铸件的腹板上加上肋条,以增强其强度和刚度.

Hysteretic linear include linear stiffness and the linear damp.

迟滞非线性包括了非线性刚度和非线性阻尼.

A dynamical angular rigidity measuring method is given based on modal analysis.

针对挠性接头角刚度的测量,提出了一种基于模态分析的动态角刚度测量方法.

The frame is one of the important components of the rotary-forging machine.

机架是摆辗机的关键零部件之一,机架的强度和刚度直接影响到所加工零件的质量.

The requirement for a good test fixture is maximum stiffness for the lightest possible weight.

一台好的试验固紧装置应该是重量轻而刚度大.

In general the bearing will be'non-linear ', the stiffness depending upon the value of h.

通常轴承是 “ 非线性 的”, 它的刚度随h值而变.

What is the feature of general element stiffness matrix?

一般的单元刚度矩阵有什么特点?

The selection range of reasonable stiffness of the CA mortar was obtained.

在此基础上,进一步得出了合理的CA砂浆 刚度取值范围.

The rigidity of the metal caused it to crack.

这金属因刚度强而产生裂纹.

This combination process is called the assemblage of stiffness matrices.

这种组合的过程称为刚度矩阵的装配.

Approximate Calculation of Shear Stiffness of Build-up Arched Pipeline Bridge.

组合管拱抗剪刚度的近似计算.

In many open-loop machines, there is single-valued relationship between loading rate and stiffness during dynamic testing.

许多开路机器在动态试验时,加载速度和刚度之间只有单值关系.

The beam has a constant flexural rigidity.

该梁具有常数弯曲刚度.

These methods are: diagonal braces, shear walls, and joint rigidity ( frames ).

这些方法有: 对角撑, 剪力墙, 连接刚度 ( 框架 ).

On composite axial compressive rigidity of steel skeleton-steel pipe concrete concentrically compressed short column

钢骨-钢管混凝土轴压短柱的组合轴压刚度研究

Study on Optimal Generalized Coupled Stiffness of Electrohydraulic Load Simulator

电液负载模拟器最佳广义连接刚度的分析研究

Because of the existence of prestress, the compressive region is enlarged and the primary bending stiffness is developed.

在正常使用状态下，由于预制断面上荷载预应力的存在，增大了断面的有效受压区面积，从而提高了叠合构件的初期抗弯刚度。

The Calculation of Progressive Rate Springs Using Principle of Complementary Energy

应用余能原理求解渐变刚度钢板弹簧

This paper mainly deals with the secant method used on stiffness matrix.

主要说明割线法在刚度矩阵上的应用.