压力的例句大全

The suction plate shall contain a replaceable 400 Series stainless steel wear ring to match the impeller wear ring.

负压力板应该包含一个能够与叶轮抗磨环匹配的可替换400系列不锈钢抗磨环。

Bore frame should be adjusted, that is to say, the pressure has few differences at one whole barefoot interval and density of the drill fluid should be big enough before drilling.

调整井身结构，在一个裸眼井段内不能有压力悬殊的地层存在，在揭开储层前，应适当提高钻井液密度。

The arterial baroreceptor reflex plays a buffering role in the cardiovascular responses to the renal afferent impulses;

动脉压力感受性反射具有缓冲肾传入冲动对心功能的抑制作用；

The study of baroreceptor reflex function before and after bed rest

卧床前后压力感受性反射机能变化的研究

An electronic model of computer-aided design for carotid sinus baroreceptor reflex system

颈动脉窦压力感受器反射系统的模拟电路及计算机辅助设计

The Change of baroreceptor reflex function during the increased orthostatic load

立位负荷量增加时压力感受器反射功能的变化

Effects of Central Cholinergic System on Carotid Sinus Baroreceptor Reflex and Its Mechanism

中枢胆碱能系统对颈动脉窦压力感受性反射的影响及其机制

A method to estimate the open-loop gain of arterial baroreceptor reflex in normal human subject

正常人动脉压力感受器反射开环增益的计算方法

The pressure of having to take a test causes a lot of tension.

要考试的压力带来了很大的紧张。

The boiler's testing pressure is different with the years of its operating.

锅炉的试验压力是随使用年限而不同的。

Using common testing pressure data to interpret formation parameters

用常规试油压力资料解释地层参数的方法

Considering the effects of temperature, pressure and excessive air, the probably product and its volume percentage were forecasted after complete combustion.

考虑温度、压力和过量空气系数对产物的影响，从而预测完全燃烧后的可能产物及其所占百分比。

The pressure transient behavior of a horizontal well and the type curve

水平井压力形态及典型曲线

Experimental research on mechanical behavior of concrete under biaxial tension compression after high temperature

高温后混凝土双轴拉-压力学特性试验研究

The unit pressure in backward extruding hollow billet has been calculated by the slip line method and the upper bound method.

本文对空心件反挤的单位挤压力，采用滑移线法和上限法进行了计算。

Theoretical Analysis of Rolling-Force for Bimetal Composite Thin Plate

双金属复合带材轧制压力的理论分析

Study on the Graphic Method Used in Feed Proportioning for Rolling down of Bimetallic Composite Theoretical Analysis of Rolling-Force for Bimetal Composite Thin Plate

双金属复合轧制图解法配料的研究双金属复合带材轧制压力的理论分析

Marangoni condensation heat transfer for binary mixture vapor at different vapor pressures

不同蒸气压力下的Marangoni凝结换热特性

SiC powders were treated by spray pelletization, and the influences of processing conditions and binder content on the crushing behavior of SiC granule during compaction were investigated.

采用压力喷雾造粒的方式对SiC粉体进行喷雾造粒处理，研究了喷雾造粒过程中工艺条件和浆料中粘合剂含量对成型过程中粉料颗粒破碎行为的影响。

Different body molding pressure, optimal value ceramic binder content is different.

不同的坯体成型压力下，陶瓷粘结剂含量最优值是不同。