圈的例句大全

Your red-rimmed eyes reveal that you have been crying.

你眼圈红红的说明你哭过了.

At noon and eat the rice noodles, the taste is not very good!

中午又去吃了米粉, 感觉味道不是特别好! 买了甜甜圈和香蕉饮料,味道不错.

Be sure the grease is worked under the bearing cage and in rib and roller ends.

并确保油脂在轴承罩内、轴承滚珠和护圈上工作.

Sitting on chair, shoulder circle slowly rhythmically, two shoulders moving forward-and-backward together. Doing 15 times respectively.

坐在椅子上, 肩膀慢慢地、有节奏地做画圈动作, 两肩一起向前,一起向后. 各做十五次.

In rhythmic gymnastics, competitors use apparatus such as the rope, hoop, ball, ribbon and clubs.

在韵律操的比赛中, 参赛运动员使用绳 、 圈 、 球 、 带、棒等器械.

If all this sounds like Europe as a giant Rhineland economy, that is no accident.

如果有人觉得这样的态势是想把欧洲变成大莱茵经济圈, 也不会让人感到意外.

Any solenoid with burnt coils is to be rewound.

任何电磁开关的线圈如果烧焦则重需重新缠绕.

Exhaust boiler damper motor is rewound, installed and tested after changing brake coil.

废气锅炉挡控板控制电机又坏了, 在更换了闸皮线圈后安装和调试.

Stator coil found burnt and to be rewound.

定子线圈发现已烧坏,将其重绕.

As the winding insulation has aged, the value is close to zero. Please rewind the motor.

由于绕组的绝缘老化, 其数值接近于零, 电机线圈需要重缠.

A vortex cage located in the vortex counts the revolutions of the vortex pool.

放置在涡流中的涡流笼圈计数出涡流源的转数.

Rotate the pinion gear several complete revolutions to align the bearing rollers.

转动主动齿轮若干圈以校正轴承滚柱.

Retro roll : A roll of the hoop in any direction which returns to the gymnast.

回旋滚: 一种圈操动作.

The Emperor and his retinue were framed by the escort and fell from power.

皇帝及他的随从们被内宫护卫所谋害,被逐出权力圈子.

Where needle bearings are used, tape the bearing retainers to the shaft to avoid losing needles.

如使用滚针轴承, 应用布带捆住轴承护圈,以避免滚针失落.

The seat ring may be removed and replaced by pulling out the two retainers.

通过取出两个线圈固定器可以拆卸和更换.

Lift retainer and check assembly from valve body.

从阀体内取出护圈和止回阀总成.

With the retainer wires removed, the seat ring can be lifted straight up and removed.

拆卸固定器线圈后, 阀座环就可以直接取出并拆卸.

Kit includes: Seat, Seat oring, Retainer Wire and Cover O ring.

组件包括: 阀座, 阀座O形环, 固定器线圈和阀盖O形环.

The top of retainer must drop just below threads in the valve body.

护圈上方必须放置在阀门阀体螺纹以下.