埋设的例句大全

Verify the correct spacing between the embedding devices.

判断埋设设备正确的间距.

It is important for drawing quality of borehole in the diaphragm wall to monitor its displacement.

在防渗墙内埋设测斜仪监测墙体位移,至关重要的是测斜孔的成孔质量.

Machines on floor without anchors. Therefore the cost and time of installation can be greatly saved.

安装机床不需埋设地脚螺栓,缩短安装周期,节省安装费用.

The enemy mined under the wall.

敌人在墙下埋设了地雷.

Other processes are similar to PVC pipes.

其馀标准与PVC管埋设工程相同.

The soldiers gained on the enemy's site and began to bury mine.

战士们接近了敌人的阵地并开始埋设地雷.

We adopt water-jet method to embedded well point pipe.

我们采用" 射水法"埋设井点管.

According to the relative criterion requirement, the subsea cable should be buried under seabed 1.

根据规范要求, 油田平台间海底电缆需要埋设在泥面以下1.

The cause mine pillar destruction Tin Mine was analyzed from observation by photoelastic mine stope 570.

通过对埋设于570中段光弹性应力计的观测,分析了该中段矿柱破坏的情况及原因.

The pile repletion measurement, drilling, the embedment of the steel casing and pile drilling are emphasized.

强调了桩位复测、护筒埋设 、 钻孔 、 成孔等每道工序在检查过程中需注意的问题.

All buried lines are coated with a protective covering to save them from corrosion.

所有埋设的管道必须涂上保护层,以防生锈腐蚀.

Buckling equation of the spanning pipe buried in elastic soil is established.

建立了两端埋设在线弹性土壤中的悬跨管道的屈曲方程.

For in-depth analysis of loading transfer and bearing capacity property on pile body, preliminarily we had arranged rebar stress gauge on trial pole main reinforcement to measure pile body axial stress and inbuilted stress box under the pile to survey tip resistance.

为了进一步分析桩的荷载传递和承载力性状，预先在试验桩主筋上布置钢筋应力计以测量桩身轴向应力，在桩底埋设压力盒以测量桩端阻力。

Through experimental and FEM analysis, the stress state in the side area of the steel beam and bonding behavior between concrete and embedded jumbo size steel bar are studied.

通过试验和有限元分析，研究了钢梁端部的受力状态以及埋设在混凝土剪力墙内的大尺寸方钢与混凝土之间的粘结性能，验证了使用荷载下连接节点系统的可靠性。

Apparatus embedding-setup and antetype observation of the concrete cutoff Wall

混凝土防渗墙仪器埋设与原型观测

Claymores once planted on the floor, will detonate when a zombie goes in range of it.

地雷一旦埋设在地上, 怪物走过它的范围就会爆炸.

By Way of inlaying conducting plates in the port plate the authors succeed in measuring the oil film thickness in the distributor pair and verify the correctness of the balance factor method. Meanwhile, a new e new experimental approach is for-mulated for the design of distributor pair.

通过在配油盘上埋设电容极板，作者成功地测出了配油付的油膜厚度，并验证了压紧系数法的正确性，为配油付的设计提供了一种新的实验方法。

There were three basic construction modes during the initial period of Alaska Pipeline design: conventional burial, special burial, and above ground berm or pile bent.

阿拉斯加原油管道设计有传统埋设、特殊埋设和地上敷设。