模拟的例句大全

To the question of wrinkle and drawing breakage during the rectangle box forming process, this paper describes the simulation of rectangle box deep drawing by Marc finite element analysis software.

针对矩形盒成形过程中各种形式的起皱和拉裂问题，采用MSC.Marc有限元分析软件对矩形盒深拉延成形过程进行模拟。

The numerical simulation of sheet forming can predict and display crinkling, drawing breakage and variation of sheet thickness in the process of drawing. The physical process, mechanical model and typical simulation process for sheet forming are described.

板料成形的数值模拟可以预测并显示板料在拉深过程中的起皱、拉裂、板料的厚度变化等。

A numerical method based on potential theory was developed to simulate nonlinear wave transformation over a submerged breakwater.

为研究潜堤附近水波变形现象，建立了一个模拟该现象的数值方法。

Nonlinear Wave Numerical Simulation of the Action between Wave and Perforated Caisson Breakwater

波浪与开孔沉箱防波堤作用的非线性数值模拟

Math Model of Non-linear Wave Propagation Near Permeable Breakwater

透空式防坡堤周围的非线性波浪传播的数值模拟

However, the coarser horizontal resolution ( 3 km) could capture the sea breeze but not the land breeze.

如果最小分辨率为3km，则只捕捉到海风，陆风却模拟不出来。

Three dimentional numerical model of the sea and land breeze with complex terrain

复杂地形条件下三维海陆风数值模拟

A simulation experiment using the fracturing of two-dimensional brittle glass plates is designed to study the propagation process of fracture in a brittle medium.

设计了一个二维脆性玻璃板的破裂模拟实验，以研究脆性介质的破裂传播过程。

By the use of forward modeling method, study into the P I oil layer formation sand-mud interbed effect of structure on characteristics of seismic reflection.

利用正演模拟手段，研究葡一油层组砂泥岩结构对地震反射特征的影响。

High temperature properties of continuous casting high carbon steels were measured by tensile tests with a Gleeble 1500 system and two embrittlement temperature regions of region I and region III were found.

采用Gleeble-1500热模拟试验机测量了高碳钢连铸板坯的高温力学性能，得到了第Ⅰ、第Ⅲ脆性温度区的温度范围。

The factors affecting zone broadening in capillary electrophoresis-amperometric detection ( CE/ AD) at a disk-shaped electrode were theoretically analysed, and a model equation about it was given.

从理论上分析了影响毛细管电泳柱端盘状电极安培检测区带展宽的诸因素，给出了区带展宽的模拟公式。

The system performance with MUD is also evaluated by system level simulation.

在有使用多用户侦测的情况下,系统效能藉由系统层级模拟来被评估.

A dynamic simulation performed to investigate the interactions between active sites reproduces the self-organizing process.

数值模拟了沸腾系统核化中的自组织现象. 理论分析结果与文献的试验观察相吻合.

During design stage, Sange's development department responses for pre-design and model test.

在设计阶段, 三格的研发部门执行预设计和模拟测试.

The numerical simulation process of wavefront reconstruction with this shear interferometer is given.

最后用数值方法模拟了波前恢复过程.

So far, simulation technology has merely accelerated the shift from knowledge-based to competency-based training.

迄今为止, 模拟技术仅仅在加速培训理念的转变方面发挥了作用.

Aim at the existent problem of field imitated training device of the portable ground-to-air missile .

针对便携式地空导弹野外模拟训练器材普遍存在的问题,介绍了自行研制的新型便携式 地空导弹 野外训练.

Using orthogonal optimizing design and numerical simulation methods, EFP warhead with hemispherical liner is optimized.

该文采用正交优化设计方法,利用数值模拟手段, 对球缺型EFP战斗部优化设计进行研究.

A method of simulation satellite imaging on a space-based telescope is presented.

提出了一种天基望远镜对空间目标成像的模拟方法.

The forming process for an automotive underbody cross member was simulated by the FE method.

利用有限元法模拟某汽车高强钢横梁的成形过程,通过设置拉深筋作为材料流动控制手段.