温度的例句大全

Effect of Tempering Temperature on Wearing Resistance of High Vanadium High Speed Steel

克鲁普铬钼钒高速钢回火温度对高钒高速钢耐磨性的影响

The effect of solution, reduction temperature, reduction time and pre-reduction process on the preparation of 13X loading with cuprous ion were examined and the preparing conditions were optimized.

实验考察了负载溶液、还原时间、还原温度以及预处理等方面对吸附剂制备的影响，得到了制备载铜13X吸附剂所需要的最优化条件。

The coolant temperature, intake port deposit, cranking speed and ignition timing all influence the limit with various mechanisms.

拖动转速、冷却水温度、进气道油膜残留和点火时刻等燃烧边界条件都对窗口区域造成影响。

In order to understand better the process of hydrocarbon formation and the effect of the top land crevice and the oil layer of the cylinder liner on unburned hydrocarbons during cold start and idling period, the temperature of piston top land and liner has been measured.

为了更好地弄清起动和怠速时发动机缸内未燃碳氢生成过程以及顶岸间隙和油膜对缸内未燃碳氢的影响，测量了起动和怠速过程活塞顶岸壁面和缸套壁面温度。

The thesis analysis is made on the crimp property of polyester/ modified high shrinkage polyester conjugated fiber. The crimp property of three kinds of conjugated fiber in different conditions such as heat processing ways, temperature and time is tested.

对聚酯/改性高收缩聚酯复合纤维的卷曲性能进行了理论分析，并测试了不同组分比例以及不同热处理方式、温度、时间条件下的聚酯/改性高收缩聚酯复合纤维的卷曲性能。

If the temperature gets below freezing point, we should take the plants indoors.

如果温度低于冰点, 我们就应把植物搬入室内.

Strictly using meteorological observation method, dynamic changes of soil temperature in wheat sping cotton relay cropping system during theirs common growth period were studied.

严格用气象部门的观测方法，观测麦套春棉共生期间土壤温度的动态变化。

A numerical model for simulating the temperature field of titanium melted in induction furnace with a water cooled copper crucible has been developed by using the direct finite difference method.

利用直接差分法，建立了水冷铜坩埚感应熔炼过程温度场数值模拟计算模型。

The results indicate that the maximum temperature of the molten alloys is not lower than 2500K, the copper of the crucible does not enter into the ingots of alloys, and the ingots are very homogeneous.

试验结果表明，熔料可达到的最高温度不低于2500K；坩埚的铜质对熔锭并无污染；

The results indicate that: both strain and extrusion ratios are in direct proportion to crushing stress, while temperature is in inverse proportion to crushing stress. The more D-value of stress area s_1 and s_3 is, the more crushing stress.

结果表明，应变和挤压比与破碎应力成正比，温度与破碎应力成反比，受力面积s1与S3相差越大，破碎应力就越大。

The coarse crystalline LC4 alloy exhibit some superplasticity under lower temperature and higher strain rate, because it can create effective recrystallization refinement.

粗晶LC4合金在较低温度和较高应变速率条件下，因能产生有效的再结晶细化，而呈现出一定的超塑性。

The higher the calcination temperature, the larger the crystallite size.

焙烧温度越高，晶粒尺寸越大；

The results showed that the CNTs encapsulated by PBMA could be dispersed more evenly in the matrix of PP and raised the crystallizing point and increased the nucleation rate of the composite, but the crystalline rate of the composite were reduced.

实验结果表明：改性碳纳米管能够更为均匀的分布在聚合物基体中，使复合材料的结晶温度提高，成核速率增大，但结晶总速率降低。

Results showed that with temperature raising, wetting front distance and cumulative infiltration volume increased.

并建立考虑温度影响的湿润锋运移模型和累积入渗量模型，经实测资料进行验证，结果良好。

Effects of temperature on laboratory population of black cutworm

不同温度对小地老虎实验种群的影响

The dependence of disaccommodation on temperature shows that it is a comprehensive effect of the ordering effect of atoms' orientation with stress relaxation.

减落随温度的变化是原子方向有序和应力松弛的综合效应。

Test methods for environmental properties of optical fibres& Temperature cycling

GB/T8404.2-1987光纤的环境性能试验方法温度循环

Uniaxial stress and temperature cycling test

单轴应力-温度循环试验

Prices in 2013 were also affected by an important cyclical factor – sea temperatures.

2013年的三文鱼价格还受到一个重要周期性因素的影响&海水温度。

A theoretical analysis is made of the transmission characteristics of the cyclic surface temperature variations in the cylinder head.

从理论上分析了周期性温度波在缸盖内的传播特性。