蚀的例句大全

The proper selection of coatings and cathodic protection ( CP) system is effective in protecting tank bottoms.

合适的涂料选择和阴极保护系统的应用是控制罐底板腐蚀的行之有效的方法。

Research on Acoustic Emission Detection for Vertical Tank Bottoms under Different Corrosion Conditions

立式储罐罐底腐蚀状态声发射检测的实验研究

The influence of alloy ingredient on corrosion resistance of ternary boride cermet clad materials was studied.

研究了合金组分对覆层材料耐腐蚀性的影响。

Study on Corrosion Resistance of Ternary Boride Cermet Clad Materials

三元硼化物金属陶瓷覆层材料耐腐蚀性能研究

The effects of borax glass inhibitor content on oxidation resistance of C/ C composites was studied by oxidation experiments. The oxidation mechanism was analyzed on the basis of SEM results.

采用氧化烧蚀试验研究了改性剂硼玻璃含量对C／C复合材料抗氧化性能的影响，通过扫描电镜（SEM）观察分析了其抗氧化机理。

The EIS results of bonded coating indicate that three time constants were obtained during the initial immersion period, and then a new time constant appeared due to the formation of rust layer.

而对于有粘结层的涂层，其交流阻抗谱在浸泡初期具有3个时间常数，浸泡后期由于在碳钢表面生成了一层腐蚀产物，出现了1个新的时间常数。

The effect of the number of composite wrap layers, the fiber orientations of non crimp fabrics, external impact and environment factors on the compressive failure are discussed.

外界预冲击作用和环境因素&水与热的侵蚀对该复合材料-混凝土增强系统抗压破坏的影响。

Influence of Some Processing Factors on Susceptibility to Caustic Stress Corrosion Cracking of Modified Alloy 800

某些加工因素对改性800合金碱性应力腐蚀破裂敏感性的影响

An Investigation on Interface Reaction Regularity for Caustic Stress Corrosion Cracking of Fe-Cr-Ni Alloy

Fe-Cr-Ni合金碱性应力腐蚀破裂界面反应规律的研究

An aeration device for hydrogen sulfide for sulfide stress corrosion cracking test

H2S应力腐蚀试验用H2S气通设计

The result showed: windward slopes of crescent dune are basically in the process of wind erosion.

结果表明：新月型沙丘迎风坡基本处于风蚀过程；

Crevice corrosion of Cu based shape memory alloy in saline solution

Cu基形状记忆合金在生理盐水中的缝隙腐蚀

Mechanism Analysis of the Crevice Corrosion of Liquid Chlorine Steel Cylinders and Protection Methods

液氯钢瓶缝隙腐蚀的机理分析及防范措施

Influence of iron as alloying element on crevice corrosion behavior of titanium

合金元素铁对钛缝隙腐蚀性能的影响

Crevice Corrosion of Stainless Steel Seal Surface in Acetic Acid and Countermeasures

不锈钢密封面在醋酸中的缝隙腐蚀及对策

Cupric hydroxide recovery from printed-circulit plate etching waste liquor

从印制电路板蚀刻废液中回收氢氧化铜

Results Before radiotherapy and chemotherapy, hair cuticle cells arranged regularly with smooth, homogenous and shiny surface, no obvious erosion phenomenon;

结果放、化疗前，毛小皮细胞排列较规则，细胞表面光滑，无明显侵蚀现象；

According to the different industries, the requirements for epoxy curing agents are not the same. Excellent performance of the epoxy curing agent can make the cured product has good stability, high heat resistance and corrosion resistance effect.

根据各行业的不同需求，对环氧树脂固化剂的要求也不尽相同。性能优良的环氧树脂固化剂可以使得固化产物具有稳定性好、耐热性高、抗腐蚀效果好等特点。

The preparation of cuprous chloride from etching waste liquor of cupric chloride and crude copper powder was studied. The result showed that this method had many advantages, including simple process, easy operation and good quality of product, therefore it had remarkable economic and environmental benefits.

以氯化铜蚀刻液废液、粗铜粉等为原料，在常温下反应制备氯化亚铜，工艺简单，操作简便，产品质量好，具有显著的经济效益和环境效益。

Sandstone in acidic diagenetic enviroment has such characteristic as fast compaction rate, earlier compaction stage, prevalent grain solution and crushing, poor heat resistance and crushing resistance, small free growing space of authigenic mineral, poor reservoir properties and so on.

偏酸性成岩环境砂岩具有快速压实阶段较早、颗粒溶蚀一压碎现象普遍而抗热性和抗压性差、自生矿物的自由生长空间较小以及储集性质较差等特点。