误差的例句大全

Lead error would be occurred during process thread by NC lathe.

用数控车床加工精密螺纹时,在开始段和结束段会出现导程误差.

Mainly due to static ring interior hole size error processing, and surface.

主要原因是静环室内孔加工尺寸误差大, 表面毛糙.

Temperature drift error of FOG is an important factor which restrict the performance improving.

温度漂移误差是制约光纤陀螺性能进一步提高的重要因素.

The CT voltage-current characteristic test method and 10 % error curve effect are analysed in detail.

详细分析研究了电流互感器伏安特性测试方法以及10%误差曲线的作用及求取方法.

Presents a model of 3 axis CNC, establishment comprehensive error model.

以三轴数控机床为对象, 建立综合误差模型.

The error model of multi-coordinate NC tool was built on the basis of multi-body system theory.

基于多体系统理论,建立了多坐标数控机床误差模型.

The observation matrix of calibration on relative position measurement is achieved from error model.

从误差建模出发,得到基于相对位置测量的标定参数识别矩阵.

Intelligent temperature controller and PID adjustment make sure the error range of temperature within 1 ℃.

选用智能式温控仪,PID调节,保证将温度的误差范围控制在1℃以内.

This paper first explains the three mathematical features of error ratio function.

首先阐明误差比率函数的三大数学特性.

The forecast accuracy was proved to be satisfactory with an error ratio less than 6 %.

检测了模型的预测精度,结果显示误差小于6%.

The laboratorial method has a good reliability as the experimental value has a little error value.

该实验值与理论值误差较小,表明了该实验方法具有较好的可靠性.

The experimental method has a good reliability, and the experimental value has a little error value.

该实验值与理论值误差较小,表明了该方法具有较高的可靠性.

With the increase of index the model error is weakened.

随着三角多项式阶数的增加,新模型中模型误差减小了.

We thence analyze compendiously model error's influence of damage position and damage degree.

最后扼要地分析模型误差对损伤识别位置和损伤程度的结果影响.

Zero Phase Error Tracking Controller ( ZPETC ) was used to partially solve the problem.

零相位误差跟踪控制器 ( ZPETC ) 的提出部分地解决了这一问题.

The ratio error of the divider calibration with this method is at 10-7 magnitude.

结果表明:用该方法校准的分压箱,比率误差为 10-7 量级.

The influence of leveling staff error on the data of vertical crust deformation is discussed.

讨论水准标尺误差在垂直形变资料中的影响.

The rule made officially by Swiss says, that first-rate watch error is not beyond 10 seconds.

瑞士官方制定的规则说优等品机械手表每日误差应控制在10秒以内.

Error bounds for pseudoconvex multifunctions are considered.

考虑了伪凸集值映射的误差界.

End application error margin compensate method, get ideal of fixed position accuracy.

最后应用误差补偿法, 得到理想的定位精度.