齿轮的例句大全

Change the lube of gearbox once after every working season.

齿轮箱每一作业季节后需更换一次润滑油.

The parametric modeling method for loxodrome normal circular-arc spiral bevel gear was presented.

给出了斜航式法向圆弧螺旋锥齿轮的参数化建模方法.

Gear, power, longevity a saw with constant linear velocity.

齿轮传动, 功率大, 寿命长,锯带线速恒定.

RUGGEDNESS. Automotive ring gear differential. Axle shafts on roller bearings.

强度: 自动差速齿轮,滚子轴承上的刚性车轴.

Traction Axis with 2 motors, 2 pinions, rack and clearance electronic take up.

牵引轴配备两台电机, 两个小齿轮, 台架以及电子设备安装空间.

Table 1 gives the fatigue yaw moment exerted on the 4 yaw pinions.

表1给出了施加在四个偏航小齿轮上的疲劳偏航力矩.

Why don't you try tightening the pinion nut first?

你为什么不先扭紧小齿轮的螺帽?

The device can be powered electrical, pneumatic, manual, pinion rotating devices.

本产品驱动装置可采用电动 、 气动 、 手动 、 伞齿轮转动等装置.

Install the pinion mate shaft lock screw finger tight to hold shaft during differential installation.

在差速器安装期间,安装小齿轮配合轴锁螺丝,用手紧固它,以把握住轴.

Remove pinion gears from differential case.

从差速箱处拆卸主动齿轮.

Mark the propeller shaft and pinion yoke, or pinion flange, for installation reference.

在传动轴和传动轴轴轭 、 或小齿轮轴轭上作标记, 作安装的参考标志.

Install pinion front bearing, if necessary.

如需要,安装小齿轮前轴承.

End play in drive pinion bearings.

驱动小齿轮轴承的端隙.

A general 3 D parametric modeling method of drum gear is put forward.

提出一种鼓型齿轮的三维参数化建模设计的通用方法.

So the key to all loosing, sales rework, replace worn copper sleeve, loose gear resize.

于是对所有松动的键 、 销重新加工, 重新更换磨损的铜套, 对松动的齿轮重新调整.

Drive type: 30 KWfrequency conversion, ZQ 500 type reducer, independence distribute gear box.

传动型式: 30kw变频电机, ZQ500型主减速机, 独立分配齿轮箱.

Third, the width control uses the planet gear speed reducer.

其三, 宽度调整采用行星齿轮减速机.

Some problems as service life of reductor gear low and frequent accidents analysis and calculation.

包钢线材厂中轧主减速机齿轮寿命短,事故频繁.

The midheaven axis gear reduction electrically operated actuation, does not need to refuel the province space.

中空轴型齿轮减速电动驱动, 无需加油省空间.

Rotate the pinion gear several complete revolutions to align the bearing rollers.

转动主动齿轮若干圈以校正轴承滚柱.