So A new method for modification graphite anode is offered.

Fig. 4 Pt distribution in copper anode slime treatment process.

图4铜阳极泥处理过程中铂的走向与分布.

Main body is made by SS 304 stainless steel & processing by anode of aluminum metal.

全机为S304不锈钢 与 经阳极处理之高级铝合金制成.

All renascent oxygen is consumed for oxidizing metal anode to form metal oxide film.

当形成足够厚的氧化膜后,阳极的氧化速度减慢,阳极表面才析出氧气.

The adsorption phenol saturated carbon was regenerated by electrochemical technology with anode extension.

采用阳极扩展电化学氧化技术对吸附饱和苯酚的活性炭进行了电化学再生.

In addition, a few representative technologies to treat copper anode mud are introduced.

选冶联合处理.并介绍几种有代表性的工艺过程.

Qatalum project include 708 sets anode superstructure.

卡塔尔铝电解工程共包含上部结构708台.

The reverse process may proceed at the anode.

相反的过程也会在阳极上发生.

It is recommended that anodes be not fitted to face plates of higher tensile steel longitudinals.

例1:建议阳极尽可能不装在高强度钢纵骨的面板上.

Extruded magnesium rod anodes are one of the important export products of XMM Co.

挤压镁棒阳极是XMM公司重要的出口产品之一.

Soluble zinc and insoluble low carbon steel anodes are used for alkaline zinc-cobalt plating.

碱性锌钴合金电镀常采用锌阳极和低碳钢阳极.

The research progress and the development prospect of the Ti-based metal oxide anodes were introduced.

介绍了目前钛基金属氧化物阳极的研究进展及发展前景.

However, cylindrical anodes have weaknesses such as long processing cycle and poor suitability.

然而, 圆桶形阳极加工周期长,适应性差.

The effect of lanthanum on electrochemical properties of zinc anodes ribbon was studied.

研究了镧的加入对牺牲锌阳极带电化学性能的影响.

A high silicon cast iron is used an auxiliary anode and sidewall installation for fixing anodes.

实桩试验表明,用高硅铸铁作为辅助阳极材料,采用侧壁式安装方法固定阳极,是行之有效的.

Outside dimension and quality of the contact surface for the anodes.

阳极导杆接触面的外型尺寸和表面质量.

Graphite anodes are improved by activation and deposition to some extent.

活化和沉积共改性时,在一定程度上可提高石墨材料的性能.

This article introduced the technique and application of Ti-based metal oxide anodes.

本文介绍钛基金属氧化物阳极技术及应用.

The Effect of Halide Anions on Activation of Al-Alloy Anodes.

卤离子对Al-Sn-Ga合金阳极的活化作用.

The process does not require electrical current or anodes as in electroplating.

但是在电镀过程中不需要电流或阳极.

Sacrificial anodes protection can decrease the degree of corrosion wear very effectively.

牺牲阳极保护法可以有效地从抑制腐蚀的角度来减弱腐蚀磨损.