General anneal cooling rate slowest, fire rate quicker, the quenching cooling rate is quicker.

For example , heat hardening, anneal, temper and so on.

有淬火 、 退火 、 回火各种热处理设备.

Steel welding construction through vibration ageing or anneal with sufficient strength and rigidity and high accuracy.

采用全钢焊接结构,经振动时效或退火处理,精度保持性优良,具有足够的强度和刚性.

The puller also applied growing and vacuum anneal of laser crystal.

该设备也适用于多种激光晶体的生长和激光晶体的真空退火.

It can replace traditional isothermal anneal as advance heat treatment of roughcast of bearing rings.

可部分替代传统的等温退火作为轴承套圈毛坯的预先热处理.

Reducing annealing furnace: The furnace is used to anneal and reduce cold rolled carbon steels.

还原退火炉: 炉子用于冷轧低碳钢的还原退火.

To do anneal process of bearing steel rod experiments with the furnace, a set of sphe.

对轴承钢盘条在强对流罩式炉中的退火工艺进行试验, 摸索出一套球化退火和再结晶退火工艺.

What do you mean by anneal?

你说的退火是什么意思?

In glass anneal furnace, SR 70 series programmable PID modulator is used as temperature controller.

在玻璃退火炉温控中, 选用SR70系列可编程PID调制器.

And a clear band with less interferer was seen at 58.6℃ as anneal temperature.

退火温度为58.6℃时,β-actin扩增产物 的条带最清晰.

This paper direct independent reinforcement of column against, explore anneal reinforcing bar spiral hoops strengthen technology.

本文就是针对独立柱的加固, 探索用退火钢筋绕丝加固技术.

Firstly, equiaxed microstructure could be produced by treatments including hot compression and duplex anneal.

本文首先通过变形及双重退火获得了很好的等轴组织.

The films also can be annealed in air or reductive circumstance according to the requirement.

根据性能的要求也可以选择在空气中或者在还原气氛中退火.

The crystal morphology, microstructure and hydrogen-annealed formation process has distinct impact on the sag resistance.

且钨丝的晶粒形状 、 组织结构、烧氢定形工艺均对其抗下垂性能有明显影响.

We produce the annealed wire with high-quality low carbon raw materials through wire drawing, anneal process.

镀锌铁丝采用中低碳钢盘条为原材料, 按生产工艺可分为热镀铁丝和电镀铁丝.

The CPC electronic packaging materials have the best integrated properties when annealed under the temperate.

研究了不同退火工艺对轧制复合CPC电子封装材料力学性能、物理性能的影响.

The transmittance of the YSO H _ 2-annealed obviously decreases after radiation in the 200-500 nm spectral ranges.

辐照后,氢气退火的样品在200 ～ 500nm波段透过率显著降低.

The measuring results temperature resistance of the sample annealed at 500℃ was indicative of kondo effect.

结果表理,样品的电阻表现为类似近藤效应的现象.

Why shall harden steel be annealed?

'淬火'.''钢为什么要退火 呢 ?

Procedure: annealed, eddy current detection, alignment, rounded, hydrostatic testing, pickling, product inspection.

工艺流程: 退火, 涡流探伤, 矫直, 整圆, 水压试验, 酸洗, 成品检验.

Rough machining and semi-finishing of the material in its soft ( annealed ) condition.

在软 ( 退火 ) 工况下材料的粗加工和半精加工.