Preheat and Cooling functions selection.

Preheat the oven to 400 degrees.

将烤箱预先加热到400度。

Preheat the oven to 180 degree.

预热?h炉至180度.

The sensible heat given by gas is used to preheat and dry fuel.

感热的气体被用来给预热和干燥的燃料.

PREHEAT oven . While preparing filling , heat oven to recommended temperature. cheesecake on middle rack of oven.

准备原料时预热烤箱到推荐的温度, 将蛋糕放入烤架的中层.

Bake in preheated oven for 8 minutes or until firm to touch and golden in color.

在预热的烤箱里烤8分钟,直到定型呈金黄色.

Having the oven preheated seems to make it easier to peel off the paper.

先预热烤箱似乎有助于揭开纸.

Lamp starting method in which lamp filaments are preheated to facilitate lamp ignition.

通过灯丝被预热使灯点燃的启动方式.

The cabinet air proofand the and exterior layer can be fully preheated by circular heating.

箱体结构封闭,采用环流加热,温度均匀,基板内外层均能受到充分预热,冲切不易分层.

The mixture is poured into the mould preheated to the same temperature.

将混合物注入已预热到同样温度的铸模内.

Bake in the preheated oven for 25 minutes.

把菠萝片轻轻铺在面糊上.

Bake for 15-20 minutes in preheated oven.

入预热的烤箱烘焙15-20分钟.

When assembling, bearing preheated and the oil temperature is less than 120 ℃.

装配时预热轴承,油温不允许超过120℃.

Bake in the preheated oven for about 12-15 minutes until lightly browned.

入预热烤箱烘焙大约12-15分钟直到浅金黄色.

Best results are obtained by using steel preheated to a tempeature of 40 ℃.

将钢材预热到40℃,可以获得最佳效果.

Hotmelts preheating to set the temperature on a sound and liquidity, it can be used.

热熔胶预热到设定温度,具有良好的流动性后, 才能使用.

Then current through C 1, RT forms the return circuit preheating filament.

于是,电流通过C1 、 Rt形成回路预热灯丝.

Kodak Carestream Health presented showcased positive plate without preheating of environmental protection plate THERMAL DIRECT plate.

柯达柯达此不主也展出了无预热侧极板技艺的环保版材THERMALDIRECT印版.

The work provides a theoretical basis for preheating or preheating treatment according to the conditions.

给出了各种情况下的应力分布,为焊接后根据使用条件是否采取消除应力措施提供了依据.

The process factors of staining salt during workpiece preheating with salt washing are analyzed.

分析了造成工件盐浴加热时沾盐问题的工艺因素.

The key of the technology was designing ideal process by using suitable preheating method.

该技术的关键是采用合理的预热方式,设计出理想的工艺流程.