USING A VOLTMETER BACKPROBE THE PARK LAMP SWITCH OUTPUT CIRCUIT.

USING A VOLTMETER MEASURE THE FUSED B CKT.

用一个伏特计测量熔断的B电路.

And the excitation voltage and output were also fed the selector switch the digital voltmeter.

其激励电压和输出也通过选择开关接到数字电压表上.

To monitor the output voltage, a voltmeter is connected in parallel with the load resistance.

为了监测输出电压, 将一个伏特计与负载电阻并联在一起.

USING AN VOLTMETER, MEASURE THE VOLTAGE ACROSS THE RR WSS AND TERMINALS.

用电压计, 测量右后SS和 (−)端子.

The voltmeter leads are a known distance apart.

电压表的引线则按已知的距离放置.

Make sure that the ac voltmeter shows no voltage.

确保交流伏特表显示无电压.

The voltmeter shows that the voltage between the two poles of the battery is 3.6 v.

电压计显示电池两端电压是3.6伏特.

WITH THE DRB IN VOLTMETER MODE, PROBE THE ABS SYSTEM RELAY CONTROL CKT.

用DRB的伏特计模式, 探测ABS系统继电器控制电路.

To verify a switch card's specifications, the contact potential can be measured with a sensitive voltmeter.

若需验证某个开关卡的技术指标, 可利用灵敏的伏特计测得其接触电势.

The testing system was composed of signal amplifer, digital voltmeter, data acquisition unite and computer.

由信号放大器 、 数字电压表 、 数据采集器、计算机等组成测量系统.

Then connect the voltmeter to the HI and LO output terminals of the switch card.

然后将伏特计连接到开关卡的HI和LO输出端子.

An AC voltmeter ( V 2 ) is connected through Ch. 2 to a second signal source.

一个交流伏特计 ( V2 ) 通过通道2连接到另一个信号源.

The voltage of power supply suitaBle for the recorder is 9 volts.

适用于这台录音机的电源电压为9伏.

Noise is usually measured in volts relative to the generated signal.

噪声通常以其与正常信号的伏特比来标定其大小.

WAS THE VOLTAGE ABOVE 0 VOLTS IN ANY GEAR POSITION?

每个档位的电压高于1.0伏 吗 ?

If gamma particles are present, potential differences of several thousand volts can be generated.

如果存在γ粒子, 可能产生几千伏的电位差.

MC 34063 is a new low power and Volts D.

MC34063是一种低功耗的新型直流电压变换器.

Most house lighting runs at the full mains voltage of 240 volts.

大部分家用电灯在240伏特全电源电压时运行.

A voltmeter connected across A to B would read 10 volts.

两点间的电压表的读数应为10伏.

This clock must swing between ＋11 volts and ＋0 . 3 volts.

这种时钟摆幅需在+11伏和+0.3伏之间.