A modified asphalt adhesion agent was made using petroleum asphalt as base materialbutyl rubber as modifierrosin resin as tackifier and mica powder as filler.

The influence of each component on bonding of the adhesion agent has been introduced. The adhesion agent is suitable for cold construction of modified asphalt waterproof coil.

介绍各组分用量对胶粘剂粘接性能的影响，该胶粘剂适用于改性沥青防水卷材的冷施工。

Inadequate bonding strength of adhesion agent was traditionally considered to cause project quality problems, but the traditional bonding mode is only on the basis of experience.

在外墙外保温的工程质量问题中，传统认为是黏结强度不够的原因，而传统的黏结方式也只是根据经验而定的。

Six type roughness of interfacial treating, type of young concrete and adhesion agent are studied on the interface of new and old concrete.

研究了6种粗糙率沟槽处理方式，新混凝土等级，界面剂对新老混凝土粘结面抗剪性能的影响。

Adhesion agent HPAM and XC complex characteristic;

稳泡增粘剂HPAM和XC的络合性；

The melt adhesive used as the adhesion agent is solid gum and comparatively environment-friendly.

作为粘结剂的热熔胶为固体胶，比较环保。

Pyrolysis GC-MS Analysis of the Adhesion Agent

一种胶粘剂的裂解GC-MS分析

Study of a New Carpet Adhesion Agent

新型地毯粘合剂

EF-Tu is a new surface protein possessing the characteristics of an adhesion factor and that it is able to induce a proinflammatory response.

它是一种新型表面蛋白，主要在蛋白质合成过程中发挥作用，具有黏附因子的特征并诱导促炎症反应。

Association of tumor derived adhesion factor ( TAF) expression with the microvascular density and its prognostic significance in osteosarcoma

骨肉瘤肿瘤性粘附因子表达与血管密度及预后的关系

Establishment of ELISA method for detecting antibodies to E.coli adhesion factor K-88

大肠杆菌粘附因子K-88抗体ELISA检测法的建立

Variation of cell adhesion factor in senile hyperlipemia patients before and after therapy

老年高脂血症患者治疗前后细胞粘附分子的变化

Approach on valuation of calculation adhesion factor for metro vehicles

地铁车辆计算黏着系数的取值探讨

A study on the adhesion factor of pumpable concrete and its measuring method

泵送混凝土的粘附系数及其测定方法的研究

Starting from the running characteristics of the metro vehicle, it is proposed that influence of acceleration and deceleration should be considered for the calculation of adhesion factor of metro motor vehicle. The calculation formula is also given.

从地铁列车的运行特点出发，提出电传动地铁动车计算粘着系数的计算要考虑大加、减速度的影响，并提出了具体的计算公式。

For better use of the traction and braking characteristics of metro vehicle, the value of the adhesion factor between the wheel and rail should be selected reasonably, so that the vehicle is under a favorable utilization of adhesion.

为了较好地发挥车辆的牵引、制动性能，需要较合理地选择轮轨间粘着系数取值，从而使车辆处于较有利的粘着利用状况。

Treatment with Tong Xin Luo Capsule, however, both adhesion force and adhesion stress were markedly reduced ( P < 0.05 or P < 0.01).

加通心络胶囊后，细胞粘附力和粘附应力均明显下降（P<0.05或P<0.01）。

The effection of dominating processing on deposition rate, adhesion, and residual stress has been revealed.

揭示了主要工艺参数对SiO2和TiO2薄膜的沉积速率、附着力、内应力和透过率的影响规律。

Study and Measurement of Adhesion Strength and Film Stress of Ag-Cu/ Ti Substrate Bilayer Films Composite Systems

Ag-Cu/Ti双金属膜结合强度及应力研究

In the case of polymer-wood composites, the interfacial adhesion influences the stress transfer from the xylon to the polymer matrix, the mechanical properties, water absorption and dimensional stability of the composites.

对于木塑复合材料而言，木质填料与树脂基体的界面粘接程度是有效传递载荷、提高力学性能、降低吸水率和提高尺寸稳定性的关键因素。

In the paper, the operation technology of electron beam evaporation plating Aluminium Chromium alloy coating is studied The optimum technology is obtained by discussing the influence of votage, current on auter appearance, adhesion inner Stress.

本文研究了电子束蒸发镀铝铬合金涂层的制备工艺，通过讨论不同的电压、束流对膜层外观、结合力、内应力的影响，确定了合适的陈镀工艺；