The second idea: the house has6 fa ç ades.

The traditional Vienna is but one of the many fa ç ades of this city.

传统的维也纳只是这个“多面城市”的一面而已。

When the adherend is soaked in H2O, 3% HCl, 3% NaOH for 150h, shedding quantity of powder respectively is: ≤ 0.03%,≤ 0.07% and ≤ 0.04%.

粘接体系分别在水、3%盐酸溶液和3%氢氧化钠溶液中浸泡150h以上，其粉粒脱落量分别≤0.03%、≤0.07%和≤0.04%。

The stress and strain distributions in the gluing joint are considerably influenced by some factors such as the geometry of the adherend, the lap length and the adhesive thickness etc.

胶接接头中应力应变分布的具体情况取决于被粘物的几何尺寸、搭接长度以及胶层厚度等因素。

The strength decreases with the shorter distance between the clamps, increases with the increasing of the adherend thickness, but the increase is not unlimited.

另外，胶结强度随夹具之间的距离变短而降低，随被粘物厚度的增大而增大。

It is clear that increases adherend thickness or Poisson ratio as well as decreases the elastic modulus may decrease the peck value of Von Mises equivalent stress.

分析可知：高的泊松比、低弹性模量和被粘物厚的增大会使得VON MISES等效应力值显著降低。

A three-dimensional transition region exists between the bulk adhesive and the adherend, and this region is referred as the "interphase".

前言：在胶粘剂基体和被粘材料之间存在着一个三维转变相区，这一相区被称为界相。

Water-based polymer combined adhesive has the feature of environment-friendly, low cost, formula designability and good adaptability to adherend materials.

水性高分子复合型胶粘剂具有环保性、配方的可设计性、对被胶接材料的胶接适应性强、成本相对低廉等特点。

It also showed the thicknesses of adherend and mid-bondline influenced the strength of joint greatly.

对接头强度影响较大的两个因素为胶层厚度和被粘物厚度；

The bonding results are related to the interface characteristics of the adhesive and the adherend.

粘接效果与参与物质的界面性质有关。

Study on surface pretreatment of titanium alloy adherend

钛合金粘接件表面技术研究

( Influences) of 12 kinds of adhesives on strength and burning properties of the formed charcoal were investigated. Suitable adhesion agent was selected, and technology and formula were optimized.

通过考察12种胶粘剂对炭块的强度和燃烧性质的影响，优选出适用的粘结剂，并对生产工艺与配方进行了优化。

A modified asphalt adhesion agent was made using petroleum asphalt as base materialbutyl rubber as modifierrosin resin as tackifier and mica powder as filler.

以石油沥青为基料，采用丁基橡胶为改性剂，改性松香树脂为增粘剂，云母粉为填料，制成一种改性沥青胶粘剂。

The influence of each component on bonding of the adhesion agent has been introduced. The adhesion agent is suitable for cold construction of modified asphalt waterproof coil.

介绍各组分用量对胶粘剂粘接性能的影响，该胶粘剂适用于改性沥青防水卷材的冷施工。

Inadequate bonding strength of adhesion agent was traditionally considered to cause project quality problems, but the traditional bonding mode is only on the basis of experience.

在外墙外保温的工程质量问题中，传统认为是黏结强度不够的原因，而传统的黏结方式也只是根据经验而定的。

Six type roughness of interfacial treating, type of young concrete and adhesion agent are studied on the interface of new and old concrete.

研究了6种粗糙率沟槽处理方式，新混凝土等级，界面剂对新老混凝土粘结面抗剪性能的影响。

Adhesion agent HPAM and XC complex characteristic;

稳泡增粘剂HPAM和XC的络合性；

The melt adhesive used as the adhesion agent is solid gum and comparatively environment-friendly.

作为粘结剂的热熔胶为固体胶，比较环保。

Pyrolysis GC-MS Analysis of the Adhesion Agent

一种胶粘剂的裂解GC-MS分析

Study of a New Carpet Adhesion Agent

新型地毯粘合剂

EF-Tu is a new surface protein possessing the characteristics of an adhesion factor and that it is able to induce a proinflammatory response.

它是一种新型表面蛋白，主要在蛋白质合成过程中发挥作用，具有黏附因子的特征并诱导促炎症反应。