High-brightness LEDs rear-projection TVs are attracting much attention as Samsung leads the way with new products.

Mitsubishi and Samsung are selling rear projection 3-D TVs.

三菱和三星公司正在销售背投三维电视.

Early fuel injection systems could be grouped into two types: portand throttle body.

早期燃油喷射系统,可分为两种类型: 港口和节气门体.

A new electronically controlled common rail fuel injection system is introduced.

介绍了一种新的电控共轨式燃油喷射系统.

A test bench for electronic unit pump ( EUP ) fuel injection system was designed.

设计了 电控 组合单体泵燃油喷射系统试验台.

Fuel is delivered in three common ways: carburetion port fuel injection and direct fuel injection.

给气缸注入燃料一般有三种方式: 蒸发式、气门式燃料喷射、直接式燃料喷射.

The fuel supply system and the fuel injection system deal with the delivery and injection oil.

燃油供给系统和燃油喷射系统负责燃油的输送和喷射.

These sensors establish ignition and fuel injection timing, and monitor crankshaft speed variation.

这些传感器(的信号)来对点火、燃油喷射定时和曲轴速度变化监控.

This paper introduces a demonstrating system for the electronic fuel injection of the gasoline engine.

介绍了一种汽油机电子燃油喷射装置模拟演示系统.

Keep the best working status of the Fuel Injection Nozzle.

保持喷油嘴最佳工作状态.

Variable in particular diesel fuel injection advance angle and control from the very good results achieved.

特别是可变喷油提前角和柴油机起机控制取得了非常好的效果.

Prevent the corrosion and rust of the tank and Fuel Injection Nozzle.

防止油箱和喷油嘴的生锈与腐蚀.

The story of fuel injection extends back to cover a period of almost one hundred years.

燃油喷射差不多从一百年前就开始了.

Safe, dependable shutdown systems fit a range of engines and fuel injection pump governors.

安全, 可靠的关机系统适合各种发动机和喷油泵省长.

Diesel injector faults will affect fuel injection quality, cause combustion worse, and influence diesel performance.

柴油机喷油器故障直接影响到燃油的喷射质量, 导致燃烧过程恶化, 影响柴油机的性能指标.

Disconnect all fuel injection harness connections.

断开所有的燃油喷射电线束接头.

Hardware undertake various plastic mold for the design, manufacture and injection, fuel injection, screen, and printing.

承接各种塑胶五金模具的设计 、 制造及注塑 、 喷油 、 丝印 、 移印.

I plant for a number of appliance enterprises to provide sophisticated injection mold.

我厂为多家小家电企业提供精密注塑模具.

At least 3 years plastic part design or injection mold design relative work experience.

三年以上塑料件设计或注塑模具设计相关工作经验.

The structure of a temperature control box plastic injection mold and its demoulding way is introduced.

介绍了温控盒塑料件注射模的结构及脱模方法.

Through analyzing molding process of the circular plug crust , determined injection mold structure with double core-pulling.

通过对圆形插头壳体的工艺分析, 确定了双抽芯的模具结构.