Microcomputer processing of gas chromatographic analysis of petroleum cracking gas

Reason analysis of driving turbine vibration for cracking gas compressor

裂解气压缩机驱动透平振动原因分析

The cracking gas of reservoir oil is an important source of natural gas.

油藏原油的裂解气是形成天然气气藏的重要气源。

Monitoring and analysis of abnormal vibration of cracking gas compressor unit

裂解气压缩机组的振动监测与振动异常分析

Causes and Countermeasures against high co_2 content in cracking gas

裂解气中CO2含量高的原因与对策

Study on the Hydrate Method to Separate the Ethylene Cracking Gas

乙烯裂解气的水合物法分离实验研究

An Investigation on Interface Reaction Regularity for Caustic Stress Corrosion Cracking of Fe-Cr-Ni Alloy

Fe-Cr-Ni合金碱性应力腐蚀破裂界面反应规律的研究

Influence of Some Processing Factors on Susceptibility to Caustic Stress Corrosion Cracking of Modified Alloy 800

某些加工因素对改性800合金碱性应力腐蚀破裂敏感性的影响

Study on regeneration for spent caustic of ethylene cracking by chemical precipitation

化学沉淀法再生乙烯裂解废碱液的研究

Effect of cold work on the caustic stress corrosion cracking of alloy 800

冷加工对800合金抗碱性应力腐蚀破裂的影响

The results showed that the corrosion weight loss rate of high Mn steel was distinctly greater than that of medium carbon chromium steel. The high Mn steel caustic embrittlement cracking was distinct in corrosion.

结果表明，高锰钢的平均腐蚀速率显著高于中碳铬合金钢，腐蚀过程中高锰钢有较严重的碱脆开裂现象。

With an increase of the chromium content in the cast steel, active dissolving corrosion increased, however, tendency of caustic embrittlement cracking decreased.

随着钢中含铬量的增加，试验材料的活性溶解腐蚀失重增大，但碱脆开裂的倾向减少。

With increasing corrosion time the impact toughness of high Mn steel obviously decreased. The major mechanism was effect of the caustic embrittlement cracking.

随着热强碱腐蚀时间的延长，高锰钢的冲击韧度明显降低，碱脆开裂是造成高锰钢冲击韧度下降的主要原因。

The experimental results show that steel fiber reinforced self-stressing concrete can significantly increase the cracking load of penstock.

试验结果表明，钢纤维自应力混凝土能够明显地提高压力管道的抗裂承载力。

The results show that the cracking load, yielding load and destructive load of strengthen frame are improved.

结果表明，碳纤维布加固震后严重损伤混凝土框架结构，其开裂荷载、屈服荷载及极限荷载均有所提高。

A Method for Calculating Cracking Load of RC Flat Plates with Opening Strengthened by CFRP

CFRP加固RC开孔平板开裂荷载的一种计算方法

The Discussion of Calculation Methods of Cracking Load for Deep Flexural Member Diagonal Section of Reinforced Concrete

钢筋混凝土深受弯构件斜截面开裂计算方法探讨

Cracking Load Resistance and Reinforcement Design in the Anchorage Zone of Prestressed Concrete Structures

预应力混凝土结构端部锚固区的抗裂验算与配筋设计

It was shown that the ratio of cracking load to ultimate load was small.

结果表明，初裂荷载与极限荷载之比很小。

Cracking load, yield load and ultimate load are obviously higher.

开裂荷载明显提高，屈服荷载和极限荷载均显著提高。

Research on The Monitor of Delayed Cracking of Weldments with Laser-Holographic Interferometry

用激光全息法监测焊件延迟裂纹的研究