alloy的例句大全

Therefore, The applications of this low-alloy bainite cast steel to ore crusher and ore mill can remarkably increase the operational efficiency of these equipments and decrease the processing cost of ore powder.

因此，这种低合金铸钢应用于矿山行业，可明显提高破磨设备运转率，降低矿粉加工成本。

The coarse crystalline LC4 alloy exhibit some superplasticity under lower temperature and higher strain rate, because it can create effective recrystallization refinement.

粗晶LC4合金在较低温度和较高应变速率条件下，因能产生有效的再结晶细化，而呈现出一定的超塑性。

Computer Simulation for the Precipitation Mechanism of the Cubic Alloy Including Coherent Strain Energy

包含共格畸变的立方合金沉淀机制的计算机模拟

RC slab culvert, circular culvert and alloy steel corrugated culvert are applicable to the secular frozen earth area.

钢筋混凝土盖板涵、圆管涵和合金钢波管涵等都适应于多年冻土地区。

Simplified Furnace Burden Calculation for Non-ferrous Alloy Charge The Computer Optimum Burden Calculation for Cast Iron Melted in Cupola Furnace

有色合金炉料质量的简便计算冲天炉熔炼的计算机优化配料

The Effect of Cupola Coke on Improving Quality of Alloy Iron Casting

铸造焦对提高合金铸铁件质量的作用

The factors of influence on shear strength of heat curing silicone rubber/ aluminum alloy were studied.

研究了影响热硫化硅橡胶与合金铝粘合剪切强度的几个因素。

The process of cyanide copper electroplating is replaced by the proposed process of pyrophosphate electroplating copper on magnesium alloy.

用研究的焦磷酸盐镀铜工艺代替氰化镀铜工艺作为过渡铜镀层的无氰镀工艺。

Only when Sn content in Pb-Ca alloy was more than 0.6wt%, its anodic dissolution of Sn could been observed from cyclic voltammogram and had effect to eliminate the premature capacity loss.

当Pb&Ca合金中锡含量超过0.6%时才可能从循环伏安图观察到锡的阳极溶解，才能起克服早期容量损失的作用。

Influence of Thermal Cycling on Two Way Memory Effect in Cu-Zn-Al Alloy

热循环对Cu－Zn－Al合金双程记忆效应的影响

It is related to the formation of the ( GaP) 1/ ( InP) 1 single layer superlattice in the ordered alloy along [ 111] direction.

认为这与在有序合金中形成沿〔111〕方向的（GSP）1／（InP）1单层超晶格有一定联系。

CO adsorption and coadsorption with O2 on ordered alloy surface Pd { 001} c ( 2 × 2)-Mn were studied with high-resolution electron energy loss spectroscopy ( HREELS) and low energy electron diffraction ( LEED).

用高分辨率电子能量损失谱研究了O2和CO在有序合金表面Pd{θ01}c（2×2）-Ma上的共吸附。

Study on Oxidation and CO Adsorption on Rh ( 100) c ( 2 × 2) Mn Ordered Alloy Surface

Rh（100）c（2×2）Mn表面合金的氧化和吸附CO的研究

The acoustic emission characteristics reflect the macroscopic properties along rolling direction of high strength aluminum alloy.

高强度铝合金沿晶界断裂过程中的声发射信号特征反映了材料沿轧制方向的宏观性能。

Introducing the performance of spraying welding layer for nickel wearing resistance alloy.

介绍了镍基耐磨合金喷焊层的性能。

Open and close valve is equipped for front-end memory type alloy detector and upper shifting fork.

并设前端装记忆合金检测器与上拨叉配合的开闭阀。

The basic principle of carburization of silicochromium alloy in shaking ladle is simply described.

本文简述了硅铬合金摇包脱碳的基本原理。

A Primary Summary of Development of Medium Silicon-molybdeum Refractory Cast Iron Die with Graphite Spheroidized for Creep Forming of Titanium Alloy Sheets

钛合金板材蠕变成形用的中硅钼耐热球墨铸铁模具研制初步总结

Experimental research on the creep age forming for aluminium alloy 2324

铝合金2324蠕变时效成形试验研究

Optimizing Design on High Temperature Wearing Resistance Bead Welding Alloy for Valve Seal

阀门密封面高温耐磨堆焊合金优化设计