alloy的例句大全

The Application of Cored Mains Frequency Induction Furnace to Production of Zinc Alloy

锌合金生产中工频无芯感应电炉的应用

Aluminum alloy is an important light metal material in industry.

铝合金是工业生产中的一种重要的轻金属材料。

Zinc-iron alloy coatings with highly basal preferred orientation were successfully obtained from acidic sulphate electrolytes by further optimizing plating parameters.

通过一步优化沉积工艺条件，成功地制备了高基面择优取向Zn-Fe合金镀层。

The method of determination of selenium in lead basal body alloy was discussed.

高锰酸钾法测定铅基合金中的硒含量。

Inhibition effect of sodium barbital on aluminium alloy in 3.5% nacl solution

巴比妥钠对铝合金在NaCl溶液中缓蚀作用的研究

Effect of Impact Power on Corrosive Wear of Medium Carbon Alloy Steel

不同冲击功对中碳合金钢腐蚀磨损的影响

The results show that the wear resistance and hardness of coating can be enhanced by Ni based alloy coating added with SiC.

结果表明，添加SiC的镍基合金涂层能够提高熔覆层的耐磨性和硬度。

Domestic Manufacture of Hydraulic System of Casting Machine for Aluminum Alloy Ingot

铝合金锭铸造机液压系统的国产化

The heat-skin use alloy die-casting material with high thermal conductivity, which is much better for heat dissipation than normal materials and thus extends the working life of LED lights.

采用具有导热性能高的铝压铸材料，散热功能优于普通材料，增强了LED灯具的使用寿命。

The design basis of model is similarity theory, the model adopt aluminum alloy and steel structure in place of the concrete of actual bridge, backstay cable of model and actual bridge adopt the same material& reinforcing wire.

模型以相似理论为设计基础，采用铝合金和钢结构来代替原桥的混凝土材料，模型斜拉索采用和实桥同样的材料&高强钢丝制作。

Present study shows that addition a small amount of A1, Ni, etc, to the Cu-Zn alloy for condenser tules enhances the combined corrosion resistance markedly, These new alloys can be used in maritime power-station or for cooling water of unfavorable quality.

结果表明，在铜锌合金中，加入少量的铝和镍，可较明显地提高原合金的综合耐腐蚀性能，能在沿海电站、或不良的淡水水质条件下使用。

Study on the Al-Fe Combining Zone of Inserting Cast-in Iron Ring Aluminum Alloy Piston

镶圈铝合金活塞铝铁结合区的研究

At present, W and W alloy are considered as a promising candidate for plasma facing material ( PFM) of International Thermonuclear Experimental Reactor ( ITER) because of their high thermal conductivity, high melting and low sputtering erosion.

目前，钨和钨合金由于良好的热传导性，高熔点，低溅射率等优良特性被普遍认为是最有希望成为国际热核聚变实验堆（ITER）等离子体面壁材料的候选材料之一。

Hard Roll Facing Technology of Mg Alloy Wheel

镁合金机轮滚压强化工艺

Effect of laser scanning speed on phase constitution, microstructure, microhardness and wear resistance of laser-cladding stellite hard facing alloy by using of across-flow-stype CO_2 laser of power 1. 5 kW has been investigated.

本文报导应用横流式连续CO2激光器，采用不同激光扫描速度，对熔覆Stellite12钴基硬面合金的合金层的相组成、微观组织结构对耐磨性和显微硬度影响的研究结果。

Application Technology of Chromite Ore Fines for Producing Stainless Steel Master Alloy

生产不锈钢母液的铬矿粉利用技术

Phase-field Simulation of Dendritic Growth of a Binary Alloy Under a Forced Flow

相场法模拟对流作用下铝合金的枝晶生长

During the creep aging process, aging and forming would be occured simultaneously and affected mutually. The pre-deformation, pre-aging, grain size, alloy composition and so on, would impact on the resilience and ultimate performance during creep age forming.

蠕变时效成形是蠕变和时效相互影响的过程，预变形、预时效、晶粒大小、合金成分等都会对蠕变时效成形的回弹和最终性能产生影响。

The process of cyanide copper electroplating is replaced by the proposed process of pyrophosphate electroplating copper on magnesium alloy.

用研究的焦磷酸盐镀铜工艺代替氰化镀铜工艺作为过渡铜镀层的无氰镀工艺。

Only when Sn content in Pb-Ca alloy was more than 0.6wt%, its anodic dissolution of Sn could been observed from cyclic voltammogram and had effect to eliminate the premature capacity loss.

当Pb&Ca合金中锡含量超过0.6%时才可能从循环伏安图观察到锡的阳极溶解，才能起克服早期容量损失的作用。