alloy的例句大全

Exploration for Contact corrosion of Ti and Ti-Alloy and Protective Test

钛及钛合金接触腐蚀与防护试验探讨

The contact corrosion occurred between Ti or Ti-Alloy Parts and other metals in the aircraft structures is described in this paper.

本文叙述了飞机结构中钛及钛合金件与其它金属件之间所发生的接触腐蚀。

Based on EDS and SEM analysis of metal corrosion surface, the course of contact corrosion between aluminum alloy, structural steel and basaltic microfiber heat-resistant materials were proposed.

通过对铝合金、结构钢等金属接触腐蚀表面的EDS成分分析和SEM微观形貌分析，探讨金属材料与玄武岩微纤维隔热材料接触腐蚀的原因。

The characteristics of copper alloy Mold process and its effect on the properties of ductile iron and gray iron castings are presented in this paper.

本文介绍了铜合金金属型的特点及其对所生产的球墨铸铁件、灰铸铁件性能的影响；

The equipments can cast aluminum alloy, stainless steel, copper, ductile iron, gray iron, vermicular iron and different conventional metal parts.

并且可以浇铸：铝合金、不锈钢、铜、球铁、灰铁、蠕铁等不同常规金属件。

Principle and progress of shape memory alloy pipe coupling

形状记忆合金管接头的工作原理及研究进展

Application and Development of High Efficiency Aluminium Alloy Covered Wire

高效铝合金涂层焊丝的应用与发展

Study on Hydrogen Induced Delayed Cracking of High Alloy Steel in Carbonitriding Process

高合金钢碳氮共渗氢致开裂的研究

Reason Analyzed and the Precaution Measures About Delayed Cracking Appears on Cast Aluminum Alloy Housing

铸铝合金壳体产生延迟裂纹的原因分析及对策

Effect of cold work on the caustic stress corrosion cracking of alloy 800

冷加工对800合金抗碱性应力腐蚀破裂的影响

Influence of Some Processing Factors on Susceptibility to Caustic Stress Corrosion Cracking of Modified Alloy 800

某些加工因素对改性800合金碱性应力腐蚀破裂敏感性的影响

An Investigation on Interface Reaction Regularity for Caustic Stress Corrosion Cracking of Fe-Cr-Ni Alloy

Fe-Cr-Ni合金碱性应力腐蚀破裂界面反应规律的研究

Crevice corrosion of Cu based shape memory alloy in saline solution

Cu基形状记忆合金在生理盐水中的缝隙腐蚀

Melting and casting rare earth alloy with water cold copper crucible

稀土及其合金熔铸&水冷铜坩埚感应炉

Through the corrosion of platinum alloy crucible and many tests, the reasons have been found. Fe and P compound have been regarded as main corrosion materials, and some problems of testing dust sample have been put forward.

通过一起铂坩锅被腐蚀现象及其多次对比试验，找出了被腐蚀原因，确定了铁、含磷化合物是粉尘样品测定中主要腐蚀性物质，提出了用铂坩锅测定粉尘样品时应注意的问题。

In order to improve the working life of stone crusher hammers, the good and cheap low-alloy steel hammers were successfully developed through a numbers of productive tests and industrial tests.

为提高石料破碎机锤头的使用寿命，经过多次试验摸索和现场工业性试验，成功研制出价廉物美的低合金钢锤头。

The effects of different granularity proportion and volume fraction of WC grains as wear resistant phase on microstructure and abrasiveness of composite alloy were studied by experiment. The research results were then applied to wear resisting supporting roller and disc pad used in middle speed coal crusher.

试验研究了耐磨相WC颗粒的不同粒度配比和体积分数对复合合金组织及耐磨性的影响，并将研究结果应用于中速磨煤机耐磨辊胎和盘瓦。

If this low-alloy bainite cast steel to making the jaw of ore crusher or the liner of ore mill is used, their service life is 1.5~ 2.5 times longer than that of the jaw or liner making from high manganese steel;

这种材料用于制造矿石破碎机的鄂板和研磨矿粉的磨机衬板，其使用寿命比高锰钢提高1.5～2.5倍；

Therefore, The applications of this low-alloy bainite cast steel to ore crusher and ore mill can remarkably increase the operational efficiency of these equipments and decrease the processing cost of ore powder.

因此，这种低合金铸钢应用于矿山行业，可明显提高破磨设备运转率，降低矿粉加工成本。

The coarse crystalline LC4 alloy exhibit some superplasticity under lower temperature and higher strain rate, because it can create effective recrystallization refinement.

粗晶LC4合金在较低温度和较高应变速率条件下，因能产生有效的再结晶细化，而呈现出一定的超塑性。