annealing的例句大全

Quantitative results can be used to improve design and control of annealing lehrs for float glass.

计算结果可供浮法玻璃退火窑设计与控制参考.

The purpose of float glass annealing is to reduce or eliminate thermal stress in required value.

浮法玻璃退火的目的是消除或减小玻璃中的热应力.

Effect of Annealing Technology on Deep-drawing Property of DDQ Cold Sheets Rolled with CSP Hot Strips

退火工艺对CSP基板DDQ冷轧板深冲性能的影响

The maximum GMI ratio of33% of these sample was observed by annealing at200 ℃.

观察到200℃退火后样品最大巨磁阻抗效应为33%。

The optimized annealing temperature was 61 ℃ for primer ( GTG)-6.

引物（GTG）6的最适退火温度为61℃。

Investigation on Annealing Thermal Process of HPH Furnace ( I): Mathematical Model

全氢罩式退火炉退火热过程的研究（Ⅰ）&数学模型及其实测验证

Application of PLC in HPH Batch Annealing Control System

PLC在HPH罩式退火炉控制系统中的应用

There are a lot of adsorbed oxygen on the surface of unannealed Fe2O3/ SnO2 bilayer and a few adsorbed oxygen left on the surface after annealing.

结果表明：Fe2O3/SnO2膜表面，晶格氧的结合能为529.85eV，热处理前有大量吸附氧存在，在600℃退火后，大部分羟基、羰基形态的吸附氧解吸；

However, the value of magnetoresistance increased apparently after annealing and was1.74 times the unannealed sample.

而退火后磁电阻值则明显增加，是未退火时的1。74倍；

The life of the sheep shearing machine cutter after quenching is improved largely by using the new process instead of traditional spheroidizing annealing.

用于剪毛机刀片代替球化退火作毛坯预处理，淬火后刀片寿命大幅度提高。

The new temperature updating function derived is inversely proportional to a power function of the annealing time and is independent of the dimension of the optimization problems.

新的温度更新函数与退火时间的幂函数成反比，与优化问题的变量维数无关。

During the intermediate annealing, foil material rolling, the effective action has been taken to guarantee the size tolerance;

在中间热处理、箔材轧制等环节采取有效措施保证了尺寸公差；

Study on Annealing of H13 、 S7 Steel after Forging

H13、S7钢锻后退火工艺的研究

In this paper a new genetic algorithm with annealing selection ( AGA) and its improvement ( MAGA) are proposed to optimize the VAR distribution in large scale power systems.

为了解决大规模电力系统的无功优化问题，提出一种新型的退火选择遗传算法及其改进算法。

Applications: Used for the bright annealing for copper tubes and rods etc.

用途：适用于各种铜管、铜棒等材料的光亮退火热处理工艺。

Study on S7 Steel Softening Annealing Process

S7钢的软化退火

The study on TTT diagram and annealing technology of S7 steel

S7钢的TTT曲线及退火工艺的研究

Nash Equilibrium Solution by Extremum Seeking Algorithm Based on Annealing Recurrent Neural Network

利用退火回归神经网络极值搜索算法求纳什均衡解

The temperature and thermal stresses are important parameters in the process of bell type annealing.

温度和热应力是罩式退火过程中的两个重要参数.

This paper introduces a bell type electric furnace with gas forced circulating for annealing or tempering.

本文介绍江西电炉厂设计制造的电加热强对流罩式退火炉.